Installation & Assembly

12"
5 1/2"
5 1/2"
Rough-in
Standard
Wall
Floor
ONE PIECE TOILET
WATER SUPPLY LOCATION & TECHNICAL INFORMATION
TECHNICAL DATA
• Dual flush: 1/1.6 GPF
3
ATTENTION! Dimensions may vary by up to 3/8". It is highly recommended to pull
all dimensions of actual model for installation and measuring purposes.
12"
5 1/2"
5 1/2"
3"
15"
Rough-in
Standard
5 1/2"
12"
4 1/2"
10"
Supply
Position 1
Threaded
Shunk (Water
Supply Fill Valve)
Side View
Side View
Back View
Supply
Position 2
Wall
Floor
Flush GPF amount is factory
set. No additional adjustment
is required.
Tank Top View (Inside)
Half
Flush
(1GPF)
You may connect the water supply line using two different
options. In both options distance from the floor to the
center of the supply line must be 5 1/2". In Supply Position
1, the water supply is located behind the toilet and is
offset by 4 1/2" from the installed toilet's center. In supply
Position 2 the water supply line must offset by 10" from
the center of the installed toilet.
Adjust the water level in the
toilet's tank if neccessary by
rotating the adjustment
screw to increase (+) or
decrease (-) a level of water
in the toilet's tank.
Full
Flush
(1.6GPF)
Half
Flush
(1GPF)