E G D I R INSTALLATION AND CARE GUIDE B D O O W WOODBRIDGE D O R MODERN ONE PIECE TOILET R O W E G D I R B D O O W D O O W R E G Compliance with the following Plumbing Codes & Standards: D I R • 2015 Uniform Plumbing Code® • 2018 International Plumbing Code® ( IPC ) B D O O W ( UPC ) ® • WaterSense Certified Toilet D O • CSA B45.
WOODBRIDGE R DELUXE ONE PIECT TOILET READ ALL INSTRUCTIONS BEFORE UNPACKING THE PRODUCT INSTRUCTIONS THAT, IF IGNORED COULD RESULT IN DEATH OR SERIOUS INJURY CAUSED BY INCORRECT HANDLING OR INSTALLATION OF THE PRODUCT. THESE INSTRUCTIONS MUST BE OBSERVED FOR SAFE INSTALLATION.
WOODBRIDGE R DELUXE ONE PIECT TOILET DIMENSIONS/TECHNICAL DATA 10 1/4" 15 3/8" 14 1/2" 28 1/2" 14 1/4" 2 1/2" 7 1/4" 2" 13" 16 1/2" 27 1/2" 18" 1 1/2" 11 " 1 1/2" Rough-in 12" Standard IMPORTANT INFORMATION • Measurements are ± 3/8" and subject to change without notice • Please note that installer(s) must be certified or warranty will be voided.
WOODBRIDGE R DELUXE ONE PIECT TOILET WATER SUPPLY LOCATION & TECHNICAL INFORMATION Side View Back View Wall Threaded Shunk (Water Supply Fill Valve) 15" Rough-in 12" Standard Floor 12" 4 1/2" 10" Side View You may connect water supply line to the fill valve. With this model the shut-off valve may be located anywhere outside of 41/2" from center so long as the stub-out doesn't exeed 5 1/2" Wall out from wall if located behind toilet. Tank Top View (Inside) Full Flush (1.
IMPORTANT! Shut off main water supply prior to installation! REMOVE OLD TOILET 1. Shut off water supply line. If you do not have shut-off valve near the toilet shut off main water supply line. 2. Flush the old toilet and make sure that tank is empty. 3. Disconnect and remove water supply line connected to the toilet's tank. 4. Remove old toilet, bolts, nuts from the closet flange. 5. Clean closet flange area from old wax ring and putty sealant using putty knife from the base area. 6.
WOODBRIDGE R DELUXE ONE PIECT TOILET INSTALLATION INSTRUCTIONS INSTALL NEW TOILET Step 1. Lift and carefully put the toilet over the closet flange inside the outline made by template so the closet bolts can go through the mounting holes in the toilet's base. Once the bowl is in the position press the bowl down with slight twisting motion in level position towards the floor. Apply your body weight to evenly compress the wax ring to create watertight seal.
WOODBRIDGE R DELUXE ONE PIECT TOILET TOILET SEAT ADJUSTMENT Remove the seat by placing in the vertical position and lifting off. This may require quite a bit of force so we recommend wedging palms face-up at the base of the seat to pry off. Then tighten the fittings and cover with the brushed nickel plates. (Item number 2) www.woodbridgebath.
WOODBRIDGE R DELUXE ONE PIECT TOILET ADJUSTMENT & MAINTENANCE (DUAL FLUSH VALVE) Important Note: Flush GPF amount is factory set. No additional adjustment is required. This page is for reference only. All adjustments are already made by manufacturer. 1.
WOODBRIDGE R DELUXE ONE PIECT TOILET ADJUSTMENT & MAINTENACE (FILL VALVE) Important Note: Flush GPF amount is factory set. No additional adjustment is required. This page is for reference only. All adjustments are already made by manufacturer. Instructions: When valve installed, the critical level mark on fill valve (identified by C.L. mark on valve body) shoud be at least 1" above top of the over flow pipe.
WOODBRIDGE R DELUXE ONE PIECT TOILET CLEANING & TROUBLESHOOTING (FILL VALVE) FILL VALVE CLEANING Shut off water supply line before filter cleaning. Carefully, take out the filter from inlet by using pliers. Use water to wash and clean the filter and adapter from any debris. Re-install the filter and re-connect the water supply line.
WOODBRIDGE R NOTES INSTALLER INFORMATION DATE OF INSTALL: INSTALLER’S NAME: PLUMBER: CONTRACTOR: LICENSE #: www.woodbridgebath.
LIMITED WARRANTY COVERAGE WOODBRIDGE R 5 YEARS TOILET BOWL & TANK TOILET RESPONSIBILITIES OF OTHERS R WOODBRIDGE warrants its toilet bowl & Tank against fading /staining of the glaze as a result of a defect in materials and workmanship for a period of five(5) years from the purchase date. SCRATCHES ARE NOT COVERED UNDER WARRANTY. Inspecting the unit prior to installation is the responsibility of the installer or building contractor who acts on behalf of the user.