Owner Manual

WOODBRIDGE

www.woodbridgebath.com

WOODBRIDGE



Note:

Cut off power prior to discharging

the water.

Self-cleaning waterway maintenance：

Self-cleaning Waterway Maintenance

When the self-cleaning waterway is blocked,

there is no water coming out during self-cleaning

process.

Current-limiting nut

Current-limiting shaft

Deodorizing Device Maintenance

Removal and Installation of Clamp

Unscrew the screws, take out the deodorant box, and replace the none-photocatalyst.

※ It is recommended to replace the none-photocatalyst after 3 years of use (the specific life

span depends on the environment).

※ If you need to replace the none-photocatalyst, please purchase it in the official online store.

1. Turn off the angle valve.

2. Unplug the power plug, cut off the power.

3. Remove the seat, press current-limiting shaft in the middle with a flat-blade screwdriver, then reinstall the seat, and open

the inlet valve.

4. If there is still no water coming out after pressing current-limiting shaft, use a flat-blade screwdriver to unscrew current-limiting

nut, remove current-limiting shaft, and clean it with a toothbrush or small brush. After cleaning, replace current -limiting

nut and current-limiting shaft to the restrictor In the device, then reinstall the seat, and open the inlet valve.

Deodorizing

cartridge

Removal: Open the clamp

cover, rotate it

counterclockwise, and use a

flat-blade screwdriver to pry

the clamp out of the slot.

Installation: Install the

quick-released connector of

water inlet pipe into the main

unit, and clip the clamp into the

slot.

b. The clamp is rotated until the

opening faces down.

c. Close the clamp cover

None-photocatalyst