manual

Included:

UNIVERSAL LENS SUPPORT (15mm LW)

NOTE: LENS SUPPORT comes with factory installed

1/4-20 SCREW. To remove and install additional

adapters follow the steps below.

1. Select LENS SUPPORT, loosen thumscrew, locate and

loosen TIGHTENING KNOB to remove 1/4-20 SCREW.

2. Choose desired adapter type. For example: select and

tighten Y BRACKET to LARGE EXTENSION and install as

shown below.

3. Select LENS SUPPORT, insert Y BRACKET, insert

TIGHTENING KNOB, adjust left or right position and up

or down to proper lens height, tighten THUMBSCREW

until vertical & horizontal position is secure.

ROLLING Y BRACKET

3/8-16

TIGHTENING

KNOB

EXTENSIONS

SMALL & LARGE

15mm LW

1/4-20

THUMBSCREW

4. Place LENS SUPPORT on RODS and tighten using

THUMBWHEELS.

5. Unlock THUMBSCREW, center Y BRACKET position

under LENS, adjust height and re-tighten THUMBSCREW.

RODS

THUMBWHEEL

LENS

LARGE EXTENSION