Warranty

For more information contact…
WOODFORD MANUFACTURING COMPANY
2121 Waynoka Road, Colorado Springs, Colorado 80915 • Phone: [phone] • Fax: [phone]
To view our complete product line visit: www.woodfordmfg.com
or email: [e-mail]
A Division of WCM Industries, Inc.
WARNING:
Install THERMALINE beside rather than under
mobile home to facilitate service of unit.
1. Carefully remove the Heater Assembly, taped to the side of
the unit, and set aside.
2. Install THERMALINE so that outlet is 4 inches above grade
or to the specifications of the local plumbing code and so
that the valve body is below all danger of frost.
3. Flush gravel, debris, etc. out of the supply line before
connecting hydrant.
4. To protect the hydrant supply connection from ground
heaving or settling, connect the THERMALINE to water
supply pipe with brass fittings and a flexible supply line.
5. Remove the orange Cover assembly.
6. Plumb to ¾” N.P.T. outlet.
7. Remove plastic cap to expose Thumb Nut. Insert the
Heater Assembly through the Heater Well Thumb Nut
located on top of the round handle. Push the rubber Heater
Cover down over the Thumb Nut.
8. After installation, check all connections for leaks.
9. Replace the orange cover assembly.
10. Plug power cord into a grounded 110-120v electric outlet.
11. Follow winterizing instructions when unit is not electrically
heated or unit may freeze and burst.
NOTE: Using the THERMALINE for an electrical ground is a violation of
the NATIONAL ELECTRICAL CODE.
THERMALINE
®
SEE INSTALLATION INSTRUCTIONS LOCATED UNDER ORANGE COVER ON UNIT
Rev 02/12 Form No. IITL.104