4915 & 4916 Standard Miter Gauge Owners Manual Please Read Carefully!
4915 & 4916 Parts List Please identify and verify that you have all of the hardware shown below prior to assembly. Part# 4900A Part# 4900G Description Qty. Nylon set screw 10 Description T-Slot Washer Part# WB002 Description 1/4” Washer Qty. 3 Part# MF045 Description 1” Screw Qty. 1 Part# HB020 Description 3/4” Bolt Qty. 2 Part# MT015 Description 3/4” Screw Qty. 1 Part# MF001 Description 5/16” Screw Qty. 2 Part# WB001 Description 3/16” Washer Qty. 1 Qty.
BEFORE BEGINNING The Standard Miter Gauge is a precision tool and should be handled and cared for as such. It is very important that the miter slot is parallel to the saw blade for this, or any other miter gauge, to work properly. Identify and verify that you have all the parts listed. Read the instructions at least once, familiarizing yourself with the parts and assembly options, before beginning assembly.
SETTING ANGLES The indexing knob (5535, pre-installed for shipping) fits through an indexing hole (select the angle you desire) in the miter gauge. We have installed bronze bushings for wear purposes at the most common angle locations. When using an indexing knob to set an angle, you will need to loosen the handle and remove the indexing knob. Re-install the indexing knob and tighten the handle after changing to the new angle setting. When not used for indexing, screw the indexing knob in the knob holder.
