Company Chipper User Manual

18
PN-51210 (Rev. 7/98)
Important!
Check the bolts on the following for correct torque (75 ft. lbs.) every
10 hours of operation:
 Hydraulic feed roller bearing
 Hydraulic motor mounting
 Chipper rotor bearing
 Chipper blades
 Rotor paddles
 Chipper anvil
Warning: Failure to maintain proper fastening torque (75 ft. lbs.) on bolts
for the components listed above may result in severe damage to the chipper
and/or personal injury!
The PTO model has ten grease zerks. Minimal periodic greasing is needed
on these points every 50 hours:
 Four grease zerks on the PTO shaft itself.
 Two greaseable bearings on the rotor shaft.
 Two greaseable bearings on the bottom jack shaft.
 One idler arm pivot
 One discharge chute
S ERVICE AND M AINTENANCE
Greaseable Bearings