Company Chipper User Manual

PN-51210 (Rev. 7/98)

AFETY

NSTRUCTIONS

• Visually check that all screws, nuts, bolts, and other fasteners are properly

secured before starting the machine. Check all screws, nuts, bolts, and other

fasteners once every 10 hours of operation for proper tightness to insure

everything is in proper working condition.

• Empty the cutting chamber before starting the machine.

• Exclude pieces of metal, rocks, bottles, cans, and other foreign objects

when feeding chipable material into the machine.

• Shut off the engine or PTO and allow the machine to stop if the cutting

mechanism strikes any foreign object or if the machine starts making an

unusual noise or vibration. After machine stops:

a) Inspect for damage.

b) Replace or repair any damaged parts.

c) Check for and tighten any loose parts.

• Do not allow processed material to build up in the discharge area; this may

prevent proper discharge and result in kickback of material through the feed

opening.

• Do not allow hands or any other part of the body or clothing inside the

feeding chambers, discharge chute, or near any moving part.

• Keep all guards and deflectors in place and in good working condition.

• Stand clear of the discharge area when operating this machine.

• Keep your face and body back from the feed opening.

• Do not over reach. Keep proper balance and footing at all times.

• Do not transport or move machine while the machine is running.

 Disengage PTO and shut off tractor engine if the machine becomes clogged.

Allow machine to come to a complete stop before clearing debris.

WARNING: Keep body and clothing away from PTO shaft when running.

• Connect 3 pt. hitch pins and snap pins, connect PTO shaft, and have leg

stands solidly on the ground when in use.

• Lock the rotor by inserting a bolt or punch through the locking holes on the

side of the rotor housing before moving. To move unit: shut off PTO and lift

3 pt. hitch.

• Keep guards and shields in place at all times while operating. Disengage

tractor PTO and shut off engine before removing guards or shields.

• Keep hands, feet, and clothing away from all PTO drive parts.

• Never clean, lubricate, or adjust the chipper when it is running.

Operation