User Guide

Safety 11
MAN0654 (Rev. 10/19/2007)
10 - PN 33347
33347E
14 - PN 1004114
(Safety Decals continued on next page)
CRUSHING AND PINCHING HAZARD
 Be extremely careful handling various parts of the machine.
They are heavy and hands, fingers, feet, and other body
parts could be crushed or pinched between tractor and
implement.
 Operate tractor controls from tractor seat only.
 Do not stand between tractor and implement when tractor
is in gear.
 Make sure parking brake is engaged before going between
tractor and implement.
 Stand clear of machine while in operation or when it is
being raised or lowered.
WARNING
TO AVOID SERIOUS INJURY OR DEATH:
 Read Operator's Manual (available from dealer) and follow
all safety precautions.
 Keep all shields in place and in good condition.
 Operate mower from tractor seat only.
 Lower mower, stop engine and remove key before
dismounting tractor.
 Allow no children or untrained persons to operate
equipment.
 Do not transport towed or semi-mounted units over 20 mph.
WARNING
WARNING
FALLING OFF CAN RESULT IN BEING RUN OVER.
 Tractor must be equipped with ROPS (or ROPS CAB) and
seat belt. Keep foldable ROPS systems in "locked up"
position at all times.
 Buckle Up! Keep seat belt securely fastened.
 Allow no riders.
RAISED EQUIPMENT CAN DROP AND CRUSH.
 Before working underneath, follow all instructions and
safety rules in operator's manual and securely block up all
corners of equipment with jack stands.
 Securely blocking prevents equipment from dropping from
hydraulic leakdown, hydraulic system failures or
mechanical component failures.
1006681
WARNING
DO NOT EXCEED PTO SPEED OF
540 RPM
PTO speeds higher than 540 RPM can cause
equipment failure and personal injury.
3 - PN1006681
DANGER
ROTATING DRIVELINE
CONTACT CAN CAUSE DEATH
KEEP AWAY!
DO NOT OPERATE WITHOUT -
 All driveline guards, tractor and
equipment shields in place
 Drivelines securely attached at both ends
 Driveline guards that turn freely on
driveline
18864-C
11 - PN18864
CONTACT WITH ROTATING PARTS
CAN CAUSE SERIOUS INJURY.
WARNING
15502--B
ROTATING COMPONENTS
Do not operate without cover in place.
Look and listen for rotation. Do not
open cover until all components have
stopped.
5 - PN 15502
If shaft connection is visible, shield
is missing. Replace shield before
operating equipment.
DANGNGERER
1004114
PN1006348 (See Figure 16)
WARNING
RELEASE ALL AIR PRESSURE BEFORE LOOSENING BOLTS.
FAILURE TO DO SO COULD RESULT IN SERIOUS INJURY OR DEATH.
MAX. SPEED: 20 MPH, MAX. WEIGHT: 4000 LBS., MAX. AIR PRESSURE: 40 PSI.
1006348
EXPLOSION
HAZARD
SAFETY & INSTRUCTIONAL DECALS
ATTENTION! BECOME ALERT! YOUR SAFETY IS INVOLVED!
Replace Immediately If Damaged!