User Guide

40 Assembly
MAN0654 (Rev. 10/19/2007)
Install Tongue
1. Align tongue (1) with top holes on the inside of
mast plates.
2. Assemble 3/4 x 2-1/2 bolt (4), 3/4 washer (2), 3/4 x
1-1/8 x 5/8 bushing (18), washer (3) and nut (19).
As shown in Figure 35.
3. Attach attitude rod (27) to tongue as shown in
Figure 35. Secure with clevis pin (9) and cotter pin
(20).
4. Attach H-frame (5) to front of tongue (1) as shown,
secure with clevis pin (7) and cotter pin (8).
5. Raise front of cutter and install parking jack (28) to
support tongue.
6. Attach safety tow chain (26) to tongue using 3/4 x
2-1/2 bolt (4) and 3/4 washer (2).
Figure 35. Tongue and H-Frame Installation
1. Tongue
2. 3/4 Flat washer
3. 3/4 Washer, thick
4. 3/4 NC x 2-1/2 HHCS
5. H-Frame assembly
6. Drive shaft shield
7. 5/8 x 5-21/32 Clevis pin
8. 3/16 x 1-1/2 Cotter pin
9. 1.00 x 2.26 Clevis pin
11. 5/8 x 5-3/4 Clevis pin
12. 1/2 NC x 5-1/2 HHCS
13. 1/2 Scdl pipe 40 x 3-9/16
14. 1/2 Heavy lock washer
15. 1/2 Heavy hex nut
16. 3/8 NC x 1 HHCS
17. 3/8 Standard lock washer
18. 3/4 x 1-1/8 x 5/8 Bushing
19. 3/4 Lock nut
20. 1/4 x 1-1/2 Cotter pin
21. 3-Joint Drive bearing housing
22. .062 x 72 mm ID Snap ring
23. 1-1/2 ID Ball bearing
24. 1/4 - 28 x 90° Grease fitting
25. Hydraulic hose holder
26. Safety chain assembly
27. Attitude rod