User Guide

Assembly 37
MAN0763 (10/10/2008)
Install CV Drive (Optional)
Before installing cutter input driveline to gearbox, check
the tag wired to the driveline and the tag wired to the
input shaft of gearbox. Ensure the tag rpm speeds
match the rpm speed decal on front of cutter. After con-
firming all speeds match, remove and discard tags and
then complete driveline assembly.
1. Align hole in drive yoke with groove on gearbox
input shaft and slide rear half of drive (23) onto
shaft.
2. Secure with bolt and nut supplied with drive.
Figure 27. CV Drive Installation
WING ASSEMBLY
Install Wing
 Use a suitable lifting device of sufficient capac-
ity. Use adequate personnel to handle heavy com-
ponents.
The wing must be installed in the following sequence
and will require at least two people. A floor jack or a
suitable lifting device will be helpful to align decks when
installing the hinge pin.
1. Remove hinge pin (13) from center section.
2. Place wing assembly adjacent to the center section
and align hinge sections.
3. Insert hinge pin through the hinge sections and
secure with spring pin (67) and washer (35) on
both ends.
4. Repeat procedure of opposite wing.
Figure 28. Right Wing Installation (Typical)
Install Wing Cylinder & Transport lock
Refer to Figure 29.
1. Slide rod end of wing cylinder (5) through box end
of wing transport lock bracket (20).
2. Place base end of cylinder and wing transport lock
bracket over cylinder lug on center section and
align holes. Secure to cylinder lug using clevis pin
(19) and two cotter pins (63).
3. Remove plug from base end of hydraulic cylinder
and rod end of cylinder.
4. Extend cylinder fully and replace plug in base end
of cylinder. This trapped air will help push wing
down.
5. Align cylinder rod end with slotted holes on wing
cylinder lugs and secure using clevis pin (18) and
two cotter pins (63).
6. Insert lock-up pin (29) in lower hole and secure
using lynch pin (40).
7. Install bushing (24) and elbow (23) to the rod end
of cylinder (5). Position elbow to point to the center
section.
8. Insert hose (25) through hose guide on transport
lock bracket and secure to elbow.
9. Repeat procedure for opposite wing.
21. CV Drive
CAUTION
13. Hinge pin
33. 1" Flat washer
64. Spring pin, 1/4 x 1-1/2
(Rev. 9/4/2009)