Company Chipper User Manual

40 Assembly
MAN0506 (Rev. 9/5/2008)
MANUAL STORAGE TUBE INSTALLATION
The manual storage tube may be supplied in either of
the following styles.
For One-Piece Style Manual Tube:
Mount the manual tube to the inside of the shredder
side sheet, using three 3/8 x 1-1/4" hex bolts, washers,
and 3/8" nuts. Mounting holes are located above the
bearing plate (see Figure 46).
Figure 46. One-Piece Style Manual Tube Installed
For Clamp-Style Manual Tube:
1. Mount the tube clamp to the inside of the shredder
side sheet using two 1/4" self-tapping screws
(Figure 47). Mounting holes are located above the
bearing plate.
2. Place the tube in the clamp with the cap facing
forward.
NOTE: Keep the Operator’s Manual with the
shredder at all times.
Figure 47. Clamp-Style Manual Tube Assembly
OPTIONAL EQUIPMENT
RUBBER BELTING INSTALLATION
1. Remove all components from shipping carton.
Make sure that all required hardware is included.
2. Attach rubber belting and bars to front of shredder
using 3/8 NC x 1-1/2 carriage bolts and 3/8 flange
lock nuts.
NOTE: Use equal number of belting and bars on
each side of shredder.
3. Tighten all hardware.
RUBBER FLAP INSTALLATION
1. Remove all components from shipping carton.
Make sure that all required hardware is included.
2. Attach flap brackets to the front of the shredder
using 3/8 NC x 1-1/2 carriage bolts and 3/8 flange
lock nuts.
NOTE: Use flap brackets to space flap brackets
out evenly across front of shredder.
3. Attach flap bars to flat brackets using 3/8 NC x 1-
1/2 carriage bolts and 3/8 flange lock nuts.
4. Assemble rod and rubber flaps through flap
brackets and secure using 3/16 x 1-1/2 cotter pins.
5. Tighten all hardware.
6. For detailed installation instructions, see the parts
diagram and instruction sheet the comes with the
swing flap kit designed for each shredder.
Figure 48. Rubber Flat Installation (15’ Shown)
SAFETY LIGHT KIT INSTALLATION
1. Remove all components from shipping carton.
Make sure that all required hardware is included.
2. Attach dual safety lights (Figure 49) to their bases
using 1/4 NC x 1" hex bolts, washers and nuts
1. Rubber flap
2. Flap bracket, right
3. Flap bracket, left
5. flap rod
6. Swing flap bar, mast plate
7. Swing flap bar
8. 3/8 NC x 1 Carriage bolt
9. 3/8 NC Flange lock nut
10. 3/16 x 1-1/2 Cotter pin