Owner`s manual

ManualsBrandsWoods ManualsLawn Mower42C-6

Installationandserviceofthisreplaceshouldbe

performedbyqualiedpersonnel.Hearth&Home

TechnologiesrecommendsNFIcertiedprofes-

sionals,ortechnicianssupervisedbyan

NFIcertiedprofessional.

WOODBURNING FIREPLACE

Fire Risk.

WARNING

For use with solid wood fuel only.

Other fuels may overﬁ re and generate poisonous

gases (i.e. carbon monoxide).

Model(s):

• DO NOTstoreorusegasolineorotheram-

mablevaporsandliquidsinthevicinityofthis

oranyotherappliance.

•

DO NOToverre.Overringwill void your

warranty.

• Complywithallminimumclearancestocom-

bustiblesasspecied.Failuretocomplymay

causehousere.

WARNING: If the information in these

instructions is not followed exactly, a  re

or explosion may result causing property

damage, personal injury, or death.

Owner’s Manual

Operation and Care

WARNING

HOT SURFACES!

Glassandothersurfacesarehotduring

operationANDcooldown.

Hot glass will cause burns.

• DO NOTtouchglassuntilitiscooled

• NEVERallowchildrentotouchglass

• Keepchildrenaway

• CAREFULLYSUPERVISE children in same room as

replace.

• Alertchildrenandadultstohazardsofhightemperatures.

High temperatures may ignite clothing or other ﬂ ammable

materials.

• Keep clothing, furniture, draperies and other ammable

materialsaway.

INSTALLER: Leave this manual with party responsible for use and operation.

OWNER: Retain this manual for future reference.

NOTICE: DO NOT discard this manual!

Contact your dealer with questions on installation, operation, or service.

Heatilator•A36/42C,A36/42CHOwnersManual•4017-263•RevD•05/01/14

A36C, A36CH

A42C, A42CH

Summary of content (24 pages)

PAGE 1
Owner’s Manual Operation and Care INSTALLER: Leave this manual with party responsible for use and operation. OWNER: Retain this manual for future reference. Contact your dealer with questions on installation, operation, or service. NOTICE: DO NOT discard this manual! Model(s): A36C, A36CH A42C, A42CH WARNING: If the information in these instructions is not followed exactly, a fire or explosion may result causing property damage, personal injury, or death.
PAGE 2
Safety Alert Key: DANGER! Indicates a hazardous situation which, if not avoided will result in death or serious injury. WARNING! Indicates a hazardous situation which, if not avoided could result in death or serious injury. CAUTION! Indicates a hazardous situation which, if not avoided, could result in minor or moderate injury. NOTICE: Indicates practices which may cause damage to the fireplace or to property. • • • • Table of Contents 4 Maintenance and Service 1 Welcome A. Congratulations B.
PAGE 3
1 Welcome A. Congratulations Read this manual before installing or operating this fireplace. Please retain this owner’s manual for future references. Congratulations on selecting a Heatilator wood burning fireplace. The Heatilator fireplace you have selected is designed to provide the utmost in safety and reliability. This Owner's Manual should be retained for future reference. We suggest that you keep it with your other important documents and product manuals.
PAGE 4
B. LIMITED LIFETIME WARRANTY Hearth & Home Technologies LIMITED LIFETIME WARRANTY Hearth & Home Technologies, on behalf of its hearth brands (”HHT”), extends the following warranty for HHT gas, wood, pellet, coal and electric hearth appliances that are purchased from an HHT authorized dealer.
PAGE 5
WARRANTY CONDITIONS: • • • • • This warranty only covers HHT appliances that are purchased through an HHT authorized dealer or distributor. A list of HHT authorized dealers is available on the HHT branded websites. This warranty is only valid while the HHT appliance remains at the site of original installation. This warranty is only valid in the country in which the HHT authorized dealer or distributor that sold the appliance resides. Contact your installing dealer for warranty service.
PAGE 6
2 Product Specific and General Information A. Appliance Certification This fireplace system has been tested and listed in accordance with UL 127 and ULC-S610 standards by Underwriters Laboratories Inc. for installation and operation in the United States and Canada. This fireplace may be installed in sleeping rooms EXCEPT in manufactured homes. If installed with a gas log set, provisions for the National Fuel Gas Code must be met.
PAGE 7
3 Important Safety and Operating Information A. Fireplace Safety Most problems are caused by improper installation and operation of the fireplace. To provide reasonable fire safety, the following should be given serious consideration: • • • • • • The fire should be supervised whenever the fireplace is in use. An annual inspection should be performed on the fireplace system. Install at least one smoke detector on each floor of your home to ensure your safety.
PAGE 8
2. Grate 7. Over-Firing Your Fireplace This fireplace is designed to be used with the supplied grate or one approved by HHT. Warning! Risk of Fire! Use only the factory-supplied integral grate. • Keeps logs in place. • Allows proper air circulation around the fire. 3. Refractory The refractory is supplied to contain heat and provide an attractive interior. It will break down over time and will need occasional replacement. Small hairline cracks and discoloration are normal and do not affect its safety.
PAGE 9
WARNING HOT SURFACES! Glass and other surfaces are hot during operation AND cool down. Hot glass will cause burns. • DO NOT touch glass until it is cooled • NEVER allow children to touch glass • Keep children away • CAREFULLY SUPERVISE children in same room as fireplace. • Alert children and adults to hazards of high temperatures. High temperatures may ignite clothing or other ﬂammable materials. • Keep clothing, furniture, draperies and other flammable materials away.
PAGE 10
1. Flue Damper 3. Glass Doors The flue damper must be in the fully opened position (handle all the way to the right) during operation of the fireplace. • • Glass doors are optional. Refer to Figure 3.3 for how to properly use them. Before lighting the fireplace, verify fully open position by looking up from the inside of the fireplace. FULLY OPEN CORRECT PARTLY OPEN INCORRECT FULLY CLOSED CORRECT PARTLY CLOSED INCORRECT 2. Outside Air (Optional) Refer to Figure 3.
PAGE 11
C. Fuel Warning! For use with solid wood fuel only. Other fuels may overfire and generate poisonous gases (i.e. carbon monoxide). 1. Hardwood vs. Softwood Your fireplace’s performance depends on the quality of the firewood you use. One species of wood varies very little to the other in terms of energy content. All seasoned wood contains about 8,000 BTU’s per pound. Hardwoods have a greater density than softwoods; a piece of hardwood will contain about 60% more BTU’s than an equal size piece of softwood.
PAGE 12
5. Burning Process 3. Seasoning Seasoned firewood is nothing more than wood that is cut to size, split and air dried to a moisture content of around 20%. The time it takes to season wood varies from around nine months for soft woods to as long as eighteen months for hardwoods. The key to seasoning wood is to be sure it has been split, exposing the wet interior and increasing the surface area of each piece.
PAGE 13
E. Lighting Instructions Notice: You must establish a good draft to prevent smoke spillage into the room. The first three or four fires should be of moderate size to allow the oils and binders to be burned from the fireplace and the refractory and paint to cure. You may notice an industrial odor the first few fires. This is considered normal. Use well-seasoned wood. • • • • • • • Open the flue damper to a fully open position. Place crumpled or twisted paper under the fireplace grate.
PAGE 14
4 Maintenance and Service Warning! Hot Surfaces! Glass and other surfaces are hot during operation AND cool down. DO NOT clean fireplace until it is cooled. Installation and repair should be done by a qualified service technician only. The fireplace should be inspected before use and at least annually by a professional service person. The following tasks may be performed annually by the homeowner.
PAGE 15
Remove screws, lift top cover. 1. Remove the 4 screws. 2. Remove the screen. 3. Remove the baffle. Remove 4 screws and lift top pan off. Top Cover Cap Cap Slip Section Top Screw Screw Chase ST375 Square Termination Cap TR344/TR342 Round Termination Cap TS345/TS345P Square Termination Caps TCT375 Terra Cotta Termination Cap DTO/DTS Series Termination Cap Chimney & Termination Cap Cleaning C. Grate E.
PAGE 16
5 Troubleshooting Start Fire Problems Possible Cause Solution Can’t get fire started Excessive smoke or spillage Burns too slowly Smolders, sizzles Not enough kindling/paper or no kindling/paper Use dry kindling, more paper. Arrange kindling & wood for air movement. Damper closed/not fully open Open damper. Not enough air for fire to ignite Check for restricted cap/shroud. Open air kit (if installed). Check for flue blockage. Pre-warm flue before starting fire (refer to starting fire section).
PAGE 17
A. FAQs Hearth & Home Technologies assumes no responsibility for the improper performance of the fireplace system caused by inadequate draft due to environmental conditions, down drafts, tight sealing construction of the structure, or mechanical exhausting devices which will create a negative air pressure within the structure where the fireplace is located.
PAGE 18
nd ina y term chimne n? tio Bird's nest or leaves in termination cap? ds ar ou Overhanging tree? in gw Stron Structural changes in chimney area? Another appliance in home also exhausting air (furnace, fan, Unsealed dryer, etc.)? can lights? Overhead fan operating? Creosote buildup in flue? Air register from furnace near fireplace? Doors opening and closing? Window closed for start-up? Figure 5.
PAGE 19
6 Reference Materials ► A. Service Parts A36C, A36CH Service Parts Beginning Manufacturing Date: June 1998 Ending Manufacturing Date: Active Accelerator 36”Woodburning Fireplace 2 1 3 4 5 6 7 IMPORTANT: THIS IS DATED INFORMATION. Parts must be ordered from a dealer or distributor. Hearth and Home Technologies does not sell directly to consumers. Provide model number and serial number when requesting service parts from your dealer or distributor.
PAGE 20
A36C, A36CH Service Parts Beginning Manufacturing Date: June 1998 Ending Manufacturing Date: Active IMPORTANT: THIS IS DATED INFORMATION. Parts must be ordered from a dealer or distributor. Hearth and Home Technologies does not sell directly to consumers. Provide Stocked at Depot model number and serial number when requesting service parts from your dealer or distributor. ITEM DESCRIPTION COMMENTS #8 Traditional Refractory PART NUMBER 8.2 8.3 8.3 8.1 Traditional Refractory Pre Week 34/98 8.
PAGE 21
A42C, A42CH Service Parts Accelerator 42” Woodburning Fireplaces Beginning Manufacturing Date: June 1998 Ending Manufacturing Date: Active 2 1 3 4 5 6 7 IMPORTANT: THIS IS DATED INFORMATION. Parts must be ordered from a dealer or distributor. Hearth and Home Technologies does not sell directly to consumers. Provide model number and serial number when requesting service parts from your dealer or distributor.
PAGE 22
A42C, A42CH Service Parts Beginning Manufacturing Date: June 1998 Ending Manufacturing Date: Active IMPORTANT: THIS IS DATED INFORMATION. Parts must be ordered from a dealer or distributor. Hearth and Home Technologies does not sell directly to consumers. Provide model number and serial number when requesting service parts from your dealer or distributor. ITEM DESCRIPTION COMMENTS #8 Traditional Refractory PART NUMBER 8.2 8.3 8.3 8.1 Traditional Refractory 8.1 Hearth Refractory 8.
PAGE 23
B.
PAGE 24
C. Contact Information Heatilator, a brand of Hearth & Home Technologies 7571 215th Street West, Lakeville, MN 55044 www.heatilator.com Please contact your Heatilator dealer with any questions or concerns. For the number of your nearest Heatilator dealer, please visit www.heatilator.com. – NOTES – CAUTION DO NOT DISCARD THIS MANUAL • Important operating and maintenance instructions included. • Read, understand and follow these instructions for safe installation and operation.