International, Inc. Saw User Manual

-16-
Model W1706 (Mfg. Since 8/10)
SETUP
Once the assembly is complete, test run your machine to
make sure it runs properly.
If, during the test run, you cannot easily locate the source
of an unusual noise or vibration, stop using the machine
immediately, then review the Troubleshooting on Page
52.
If you still cannot remedy a problem, contact our Tech
Support at [phone] for assistance.
To test run the machine, do these steps:
1. Make sure you understand the safety instructions
at the beginning of the manual, and verify that the
machine is setup properly.
2. Ensure all tools and objects used during set up are
cleared away from the machine.
3. Turn the machine ON.
4. Listen to and watch for abnormal noises or actions.
The machine should run smoothly with little or no
vibration or rubbing noises.
— Strange or unusual noises should be investigated
and corrected before operating the machine
further. Always disconnect the machine from
power when investigating or correcting potential
problems.
5. Turn the machine OFF.
Test Run
Projectiles thrown from the machine
could cause serious eye injury. Wear
safety glasses to reduce the risk of
injury.
Loose hair and clothing could get
caught in machinery and cause serious
personal injury. Keep loose clothing
rolled up and long hair tied up and
away from machinery.
Additional Adjustments
After successfully completing the Test Run, the
adjustment procedures listed below must be performed to
ensure safe and accurate cutting operations (refer to the
following subsections for detailed instructions):
• Properlytensiontheblade(Page 17).
• Adjustthepositivestopbolt(Page 18).
• Alignthetablewiththeblade(Page 19).
• Squarethemitergaugebodytotheblade(Page 20).
• Alignthefencewiththeblade(Page 21).
• Adjustingthebladesupportbearings(Page 22).
• Adjustingthebladeguidebearings(Page 24).