International, Inc. Drill User Manual

-9-
W1668 13
1
⁄4" Oscillating Drill Press
SETUP
Keep machine disconnected from
power until instructed otherwise.
This machine has been carefully packaged for safe trans-
portation. If you notice the machine has been damaged
during shipping, please contact your authorized Shop Fox
dealer immediately.
Unpacking
SETUP
The following is a description of the main components
shipped with the Model W1668. Lay the components out
to inventory them.
Note: If you can't find an item on this list, check the
mounting location on the machine or examine the pack-
aging materials carefully. Occasionally we pre-install cer-
tain components for safer shipping.
Box Inventory (Figure 6 & 7) Qty
A. Headstock Assembly .......................................1
B. Table .........................................................1
C. Column ......................................................1
D. Rack .........................................................1
E. Table Bracket ..............................................1
F. Rack Ring ...................................................1
G. Base ..........................................................1
H. Dust Port Halves ...........................................2
I. Table Inserts (
5
⁄8", 1", 1
3
⁄8", 1
7
⁄8") ...................1ea
J. Sanding Mandrel ...........................................1
K. Spindle Handles ............................................3
L. Hand Crank Handle ........................................1
M. Hand Crank .................................................1
N. Lock Handle M12-1.75 ....................................1
O. Lock Handle M10-1.5 ......................................1
P. Belt Cover Knob ............................................1
Q. Key ...........................................................1
R. Drill Chuck JT33 ...........................................1
S. Pinion Gear .................................................1
T. Spindle Sander Set D2877 (not shown) .................1
Tools and Fasteners (not shown) Qty
—Special Wrench 25mm ..................................1
—Open End Wrench 13 x 14 ..............................1
—Hex Wrenches 3, 4, 5mm ...........................1ea
—Hex Nut M8-1.25 (Mandrel) ............................1
—Mandrel Washers
3
⁄4" OD x
5
⁄8" ID (Mandrel) ........2
—Mandrel Washer
7
⁄8" OD x
3
⁄8" ID (Mandrel) .........1
—Mandrel Washer
5
⁄8" OD x
3
⁄8" ID (Mandrel) .........1
—Hex Bolt M10-1.5 x 25 (Colum/Base) .................4
—Phillips Head Screws M4-.7 x 22 (Dust Port) ........4
—Cap Screw M5-.8 x 20 (Chuck).........................1
Inventory
Figure 6. W1668 inventory.
Figure 7. Additional W1668 inventory
items.
A
H
O
P
Q
R
S
I
J
K
L M
N
B
C
D
E
F
G