International, Inc. Planer User Manual

-29-
N(/(+Fne\ijDXelXcD]^%('&'/"
J<IM@:<
/% Use two 8mm wrenches to tighten the hex nut on
the inward stop as you hold the stop in place.
0% Put the limit block back, bring the fence back to 90º
and tighten the tilting handle.
Kfj\kk_\flknXi[+,²jkfg#[fk_\j\jk\gj1
(% DISCONNECT JOINTER FROM POWER SOURCE!
)% Loosen the fence tilting handle, remove the limit
block and set it aside.
*% Tip the fence back (away from the table) until it
stops.
 Efk\1K_\]\eZ\n`ccjkfgn_\ek_\flknXi[jkfg
Yfck_`kjk_\]\eZ\YiXZb\k%
+% Use a square to check the angle of the fence, as
shown in =`^li\44%
— If the fence is tilting away from the table at 45º,
the outward stop is set correctly. Put the limit
block back, bring the fence to 90° and tighten the
tilting handle.
— If the fence is not tilting away from the table at
45º, do Jk\gj,- to set the outward stop cor-
rectly.
,% With the outward stop bolt resting against the fence
bracket, use an 8mm wrench to adjust the length of
the stop until the fence is at 45º, then tighten the
jam nut (see =`^li\45).
-% Put the limit block back, bring the fence to 90º and
tighten the fence tilting handle.
=`^li\44% Checking the outward 45º stop.
=`^li\45. Outward stop bolt detail.
Outward
Stop Bolt
Jam Nut
Sharp knives provide the best cutting results. If you
need to replace the knives in your jointer, follow the
instructions for :_\Zb`e^&8[aljk`e^Be`]\?\`^_k on GX^\
(-, but after loosening the knives, remove them and
clean any dust or debris out of the knife slots, then lightly
lubricate the new knives and reinstall them, following the
instructions on GX^\(- for tightening the knife clamp
screws.
I\gcXZ`e^Be`m\j