International, Inc. Biscuit Joiner User Manual

SStteepp 22..
Remove the fence and apply a strip of masking
tape along the the rail
3
⁄16'' in from the front edge.
SStteepp 33..
Using the zero mark as the starting point and the
masking tape as a guide, apply the adhesive scale
to the rail.
FFiigguurree 2233..
Burnish the scale into place
with heavy thumb pressure.
-16- Shop Fox
®
Fence
FFiigguurree 2222..
Placement of the scale.
FFiigguurree 2233..
Attaching the scale.
GG.. SSCCAALLEE//IINNDDIICCAATTOORR
The self adhesive scale (#56) and hairline indica-
tor (#40) provide fast and accurate fence position-
ing. To mount the scale and indicator, proceed as
follows:
SStteepp 11..
Locate the zero point of the scale by measuring 2''
to the left of the blade and mark the rail.
FFiigguurree 2222..
SStteepp 33..
Continue to rotate the axle until the fence is square
to the table. Tighten the setscrew.
SStteepp 44..
It is advisable at this point to recheck parallelism
between the fence and the blade. If further
adjustment is required, continue to check back
and forth between parallelism and squareness
until both are adjusted satisfactorily. Remember
to adjust with the setscrews loose and measure
with the setscrews tight. This procedure may
seem a bit tedious, but this is a one time adjust-
ment that, if done patiently, will ensure excellent
performance.
FFiigguurree 2211..
Adjusting the left roller axle.
Rotate nut to rotate axle