International, Inc. Biscuit Joiner User Manual

Shop Fox
®
Fence
-23-
side of the front carriage. Loosen the mounting
screws slightly and shift the carriage so that it is
90˚ to the fence.
FFiigguurree 3333..
Tighten the mounting
screws and reinstall the clamping jaws. Check and
adjust the front clamping pressure as described in
SSeeccttiioonn IIIIII,, PPaarrtt DD
.
FFiigguurree 3333..
Squaring carriage on fence.
PPoossssiibbllee pprroobblleemm::
The rear carriage may be drag-
ging on the rear rail.
SSoolluuttiioonn::
Although this is unlikely, it is possible if
the rear roller (#51) is pressed onto its bearing
(#36) too far. Any one of the following
approaches may be used:
aa..
Re-install the bearing/roller upside down.
bb..
Shift the roller on the bearing in a press.
cc..
Contact Woodstock International for replace-
ment parts (#36, 49, 51 and 52).
dd..
Use a file to enlarge the rail cut-outs in the rear
carriage slightly.
FF.. FFEENNCCEE WWIILLLL NNOOTT AADDJJUUSSTT
PPAARRAALLLLEELL TTOO BBLLAADDEE
PPoossssiibbllee pprroobblleemm::
The front carriage is not mount-
ed square to the underside of the fence.
SSoolluuttiioonn::
Remove the clamping jaws to gain
access to the mounting screws (#37) on the under