User Manual

Table Of Contents

Activating a Collar:

The system allows you to activate up to 4 Collars using the

Controller. Before initiating the setup process, make sure to install a

new CR123 Battery in the Collar.

1. Position the Collar within 10 feet of the Master Base

while you are inside the house.

2. Select “Collars” from the main menu. (See Figure 5.8)

3. Select the “Add Collar” Button (See Figure 5.9)

4. Press the “Install Collar” Button (See Figure 6.0)

If successful, a positive auditory tone will sound and “Congratulations”

will appear, indicating that the Collar has been properly set. You may

proceed to name your Collar. If you choose not to name it, the Collar will

be given the default name of Collar1, Collar2, etc. For more information on

“Naming a Collar” see page 19. (See Figure 6.1)

If unsuccessful, , a negative auditory tone will sound and you will be

directed to try again. (See Figure 6.2)

Figure 6.2

Figure 6.1

Setting Up the Collars

Installing the Custom-Shape Wireless Dog Fence - Setting Up the Collars

Important Note:

The Collar should not be placed on your

dog until after you have successfully

installed it on the system.

If you plan to activate more than 1

Collar, DO NOT insert batteries in

all the Collars at the same time. It

is necessary to insert batteries and

activate the Collars ONE AT A TIME.

Each Collar uses a CR123 Battery.

Havahart

Custom-Shape Wireless Dog Fence

Figure 6.0

Figure 5.8

Figure 5.9