Installation Guide

FLASHING AND MOISTURE CONTROL:
The structure on which the RealTrim Plus™ Fascia and Trim is applied should be well vented and dry. Do not apply trim
over wet sheathing, or any closer than 6 inches to finished grade or final landscaping. As with all wood products,
RealTrim Plus™ Fascia and Trim should not come in direct contact with masonry or concrete and should be properly
flashed and spaced at least ½” from any concrete flatwork or horizontal brick ledge. At foundations or exterior brick
veneer, the product should be separated from the masonry by metal flashing, polyethylene film, 30 lb. Felt or a ¼” to
½” air space using masonry standoffs. In all applications, Fascia and Trim should not be allowed to stand in water.
Caulk and seal the Fascia and Trim applications to prevent water intrusion. Water should not be allowed to stand on or
leak behind any Trim.
(Trim used in a horizontal application must be properly flashed as indicated in the diagram below.)
FINISHING REQUIREMENTS:
RealTrim Plus™ Fascia and Trim is manufactured from wood and must be painted with an exterior coating system in
accordance with the following specifications to fulfill the warranty requirements.
GENERAL INFORMATION:
Paint performance is dependent upon the quality and quantity of paint applied, and the conditions under which it is
applied. Low quality paint and/or thinly applied paint tend to last for a relatively short time, resulting in discoloration,
premature fading, inadequate substrate protection, and frequent repainting – sometimes as often as every one or two
years. Top quality paint, applied in sufficient quantity, will provide the best performance with the minimum
maintenance. Follow coating manufacturer recommendations when selecting and applying a paint.
SURFACE PREPARATION:
The surface must be free of dust, dirt, mildew and other foreign materials before painting. Washing with water and a
mild detergent will usually remove dust and dirt. Allow the surface to dry before painting.