Specifications

Maintenance and Cleaning

08/2013-v1.0de

9.2 Lubrication

9.2.1 Bearings

All bearings in the treadmill have been lubricated at the factory and must not be lu-

bricated except for the axle bearings.

The bearings on the front and rear axle are to be lubricated with a grease gun once

a year (two in the front, two in the rear).

Fig. 21 Axle bearing

1. Aligning bearing (maintenance free)

2. Inside of the running surface belt

3. Edges of slats

4. Lubrication nipple for all four bearings / front and rear axle

The side panels must be removed for lubrication.

9.2.2 Running Surface Belt

The rubbing of the running surface toothed belt on the edges of the guide roller

may cause noises.

For relief, lightly lubricate the sides of the toothed belt (Molykote or equivalent). Al-

so apply lubricant to the teeth on the synchronization belt.