User's Manual

113
4. When the remote has been totally reset and returned to the factory default condition, a
REMOTE RESET COMPLETE message will appear (Figure 69) briefly, and then the remote
will return to normal operation.
Figure 69
Additional Notes on Configuring and Operating the Remote
• When the remote is being programmed, it will automatically time-out if no button is pressed
within a thirty second period. The message shown in Figure 70 will appear briefly, and the
remote will then exit the feature being programmed and any data entered will be lost.
Figure 70
• The programming or configuration process may also be stopped at any time by pressing the
REM MENU Button [oval 36]. The message shown in Figure 70 will appear, the data entered
in the current process will be lost and the remote will return to normal operation. Any process
that was underway when the button will be pressed must be restarted.
• Extensive use of the programming, learning and configuration functions of the remote may
consume significantly more battery power than normal remote operation. While the batteries
should last for four to six months in normal operation, you may find that they need to be
changed sooner after the remote is programmed for the first time.
• When the batteries approach a level below which the remote will not function, the remote’s LCD
screen will display a LOW BATTERY warning as shown in Figure 71. We strongly recommend
replacing the batteries as soon as this message appears to avoid the loss of programming and
configuration settings. These settings are not lost when the batteries are changed quickly.
Figure 71
• The remote has a built-in backlight that may be activated by pressing the Light Button [oval
31]. This button is made from a special “glow” material so that it is easier to find in dark rooms.
This glow feature does not consume any electricity, but the glow will fade when the remote is
kept in a dark location for an extended period of time. The “glow” feature may be restored by
placing the remote in normal room light for a few hours.
• The remote’s backlight will remain lit for approximately five seconds after the Light Button
[oval 31] is pressed, and it will stay lit for another five seconds if any key is pressed while the
backlight is on. You may keep the backlight lit by holding the Light button, but extensive use of
the backlight will reduce battery life.
• The LCD display will remain on for ten seconds after a key is pressed and then turn off to
conserve battery life.