User's Manual

SCREEN CONTROL

To drop and raise a projection screen with the AVR turn on/turn off functions, press the Menu

Button [oval 44] on the remote to bring the MAIN MENU to the screen. Press the ▼/▲

Navigation Button [oval 16] so that the cursor is pointed to the REMOTE CONTROL SETUP line.

Press the Set Button [oval 18]. The REMOTE CNTL SETUP 1 screen will appear. Press the

▼/▲ Navigation Button [oval 16] so that the cursor is pointed to GO TO REMOTE CNTL 2.

Press the Set Button [oval 18]. The REMOTE CNTL SETUP 2 screen will appear. Press the

▼/▲ Navigation Button [oval 16] so that the cursor is pointed to the SCREEN CONTROL line.

Press the Set Button [oval 18]. The SCREEN CONTROL SETUP screen will appear.

Carrier

With the cursor positioned next to CARRIER, press the ◄/► Navigation Button [oval 16] to

select the proper setting. NOTE: Most IR remotes used with common source components will

have a carrier, so YES should be selected as a first test. Some Cable Box remotes do not use a

carrier, so if a code setting doesn’t work, try changing this setting.

Invert Code

Press the ▼/▲Navigation Button [oval 16] to move the cursor next to: INVERT CODE. Press

the ◄/► Navigation Button [oval 16] to select YES/NO. Most devices will be set to NO. Certain

devices, (Sony S-Link, Harman Kardon Remote Control IN) will require a YES setting. Try

changing this setting if a specific code selection does not work for a given device.

Program Code

Press the ▼/▲ Navigation Button [oval 16] so that the cursor is pointed to the PREOGRAM

CODE line. Press the Set Button [oval 18]. The

SCREEN CODE PROGRAM screen will appear.

Screen Program Code (Manual)

Press the ▼/▲ Navigation Button [oval 16] so that the cursor is pointed to the MANUAL line.

Press the Set Button [oval 18]. The SCREEN MANUAL PROG screen will appear. SOURCE TYPE

will be fixed as selected (SCREEN).

Press the ▼/▲Navigation Button [oval 16] to move the cursor next to: BRAND. Press the ◄/►

Navigation Button [oval 16] to select the appropriate brand.

Press the ▼/▲Navigation Button [oval 16] to move the cursor next to: TRY CODES. With the

AVR21ENR1 Main Room Remote pointing toward the AVR front panel, starting with 1, slowly

press the numeric buttons through the range indicated on screen, until the unit being configured

turns off. When the unit turns off, press the ▼/▲Navigation Button [oval 16] to move the cursor

next to: YES. Press the Set Button [oval 18]. This will ‘save’ this code group for ON/OFF control

of the TV/Projector.

If no IR ON/OFF commands were found, see Automatic and Learn, below.

If no further programming is required, press the AVR Button [oval 5] on the AVR21ENR1 remote

and then the Exit Button [oval 17] to return to normal operation mode.

To continue in setup, press the ▼ Navigation Button [oval 16] to move the cursor next to: BACK

TO SCR CODE PROG. Press the Set Button [oval 18]. Press the ▼ Navigation Button [oval

16] again to move the cursor next to: BACK TO SCR CNTL SETUP. Press the Set Button [oval

18]. The SCREEN CONTROL SETUP screen will appear.

To program TV/PROJECTOR ON/OFF, LIGHTING ON/OFF, CURTAIN OPEN/CLOSE, press the

▼/▲Navigation Button [oval 16] to move the cursor next to: BACK TO REM CNTL SETUP.

Press the Set Button [oval 18]. See the TV/Projector and Lighting sections.