User's Manual

panel; or press the ON Button [oval 2] on the AVR21ENR1 remote. The AVR should turn ON

and the screen should drop.

To test OFF, either: press the Standby/ON Button [square 2] on the AVR front panel; or: press

the OFF Button on the AVR21ENR1 remote. The AVR should turn OFF and the screen should

retract.

To test the SCREEN UP/DOWN commands with MANUAL VIA REMOTE, turn the AVR OFF and

manually raise the screen. Turn the AVR ON by pressing the Standby/ON Button [square 2] on

the AVR front panel or press the ON Button [oval 2] on the remote. (The AVR should be on, but

the screen should still be retracted.) Press the Trigger Button [oval 50] on the remote. The

screen should drop. Press the Trigger Button [oval 50] again and the screen should retract.

Exit Setup

If no further programming is required, press the AVR Button [oval 5] on the AVR21ENR1 remote

and then the Exit Button [oval 17] to return to normal operation mode.

LIGHTING CONTROL

To control the Main Room lighting with the AVR turn on/turn off functions, press the Menu Button

[oval 44] on the remote to bring the MAIN MENU to the screen. Press the ▼/▲ Navigation

Button [oval 16] so that the cursor is pointed to the REMOTE CONTROL SETUP line. Press the

Set Button [oval 18]. The REMOTE CNTL SETUP 1 screen will appear. Press the ▼/▲

Navigation Button [oval 16] so that the cursor is pointed to GO TO REMOTE CNTL 2. Press

the Set Button [oval 18]. The REMOTE CNTL SETUP 2 screen will appear. Press the ▼/▲

Navigation Button [oval 16] so that the cursor is pointed to the LIGHTING CONTROL line. Press

the Set Button [oval 18]. The LIGHTING CONTROL SETUP screen will appear.

Carrier

With the cursor positioned next to CARRIER, press the ◄/► Navigation Button [oval 16] to

select the proper setting. NOTE: Most IR remotes used with common source components will

have a carrier, so YES should be selected as a first test. Some Cable Box remotes do not use a

carrier, so if a code setting doesn’t work, try changing this setting.

Invert Code

Press the ▼/▲Navigation Button [oval 16] to move the cursor next to: INVERT CODE. Press

the ◄/► Navigation Button [oval 16] to select YES/NO. Most devices will be set to NO. Certain

devices, (Sony S-Link, Harman Kardon Remote Control IN) will require a YES setting. Try

changing this setting if a specific code selection does not work for a given device.

Program Code

Press the ▼/▲ Navigation Button [oval 16] so that the cursor is pointed to the PROGRAM CODE

line. Press the Set Button [oval 18]. The LIGHTING CODE PROGRAM screen will appear.

Lighting Program Code (Manual)

Press the ▼/▲ Navigation Button [oval 16] so that the cursor is pointed to the MANUAL line.

Press the Set Button. The LIGHTING MANUAL PROG screen will appear. SOURCE TYPE will be

fixed as selected (LIGHTING).

Press the ▼/▲Navigation Button to move the cursor next to: BRAND. Press the ◄/►

Navigation Button [oval 16] to select the appropriate brand.

Press the ▼/▲Navigation Button [oval 16] to move the cursor next to: TRY CODES. With the

AVR21ENR1 Main Room Remote pointing toward the AVR front panel, starting with 1, slowly

press the numeric buttons through the range indicated on screen, until the unit being configured