User's Manual

http://www.woosim.com

[Notes] 1) When the command is input in standard mode, the printer executes only internal

flag operation. This command does not affect printing in standard mode.

2) This command sets the position where data is buffered within the printing area

set by ESC W.

3) Parameters for horizontal or vertical motion units (X or Y) differ as follows,

depending on the starting position of the printing area;

If the starting position is the upper left or lower right of the printing area, data is

buffered in the direction perpendicular to the paper feed direction.

Commands using horizontal motion unit: ESC SP, ESC $, ESC \

Commands using vertical motion unit: ESC 3, ESC J, GS $, GS \

If the starting position is the upper right or lower left of the printing area, data is

buffered in the paper feed direction.

Commands using horizontal motion units : ESC 3, ESC J, GS $,GS \

Commands using vertical motion units : ESC SP, ESC $, ESC \

[Default] n = 0

[Reference] ESC $, ESC L, ESC W, ESC \, GS $, GS P, GS \

GS $ nL nH

[Name] Set absolute vertical print position in page mode.

[Format] ASCII GS $ nL nH

HEX 1D 24 nL nH

Decimal 29 36 nL nH

[Range] 0 ≤ nL ≤ 255, 0 ≤ nH ≤ 255

[Description] Sets the absolute vertical print starting position for buffer character data in page

mode.

[Notes] 1) This command sets the absolute print position to [(nL+nHx256)]x (vertical or

horizontal motion unit) inches.

2) This command is effective only in page mode.

3) If the [(nL+nHx256)] x (vertical or horizontal motion unit) exceeds the specified

printing area, this command is ignored.

4) The horizontal starting buffer position does not move.