User's Manual

http://www.woosim.com
50
4) If the bit-image data input exceeds the number of dots to be printed on a line, the
excess data is ignored.
5) d indicates the bit-
image data. Set a corresponding bit to 1 to print a dot or to 0 to
not print a dot.
6) If the width of the printing area set by GS L and GS W less than the width
required by the data sent with the ESC * command, the following will be performed
on the line in question (but the printing cannot exceed the maximum printable area):
The width of the printing area is extended to the right to accommodate the amount
of data.
If step does not provide sufficient width for the data, the left margin is reduced to
accommodate the data.
7) After printing a bit image, the printer returns to normal data processing
mode.
8) This command is not affected by print modes (emphasized, double-
strike, underline, character size or White/Black reverse printing), except
upside-down printing mode.
9) The relationship between the image data and the dots to be printed is as
follows;