User's Manual

G aVVUUG

YWW_TW^TW^G

X Press FEED button one time, Power Lamp twinkles twice and Error Lamp

twinkles one time.

Press the MODE Button two times, and the Error Lamp twinkles three times.

(The baud rate has set to 38,400 bps)

X Press FEED Button one time, Power Lamp twinkles 3 times and Error Lamp

twinkles 2 times.

Press MODE Button one time, Error Lamp twinkles one time.

(The Data Bit has set to 7 Data bit)

X Press FEED Button one time, Power Lamp twinkles 4 times and Error Lamp

twinkles 1 time.

Press MODE Button one time, Error Lamp twinkles two times.

(The Parity bit has set to Odd parity bit)

X Press FEED Button two time, Power Lamp twinkles 6 times and

Error Lamp twinkles 1 time.

Press MODE Button one time, Error Lamp twinkles 2 times after then press

MODE Button again, the Error Lamp will twinkle 3 times.

( The Density has set to High)

If all the mode have set, press the MODE Button and the FEED Button at the same time

after then release the buttons at the same time.

The printer will print out the mode status which has modified.

(Protocol UART / 38400 bps/ 7 Data bit/ Odd parity/ 1 Stop Bit/Density high

/Mark No Use)

If the status is not correct, please try it again according to the procedure.