User's Manual

G aVVUUG

YWW^TWZTY]G

YU\UGzGGG

1. Press the Mode Button until the Error Lamp twinkles 5 times

2. Change the mode and option using the Mode Button and the Feed Button according to the

MODE code(Table1)

z Feed button : use for changing MODE status

z Mode button : use for changing OPTION status

[Example]

The defaults of the printer are:RS-232C/9600 BPS/8 DATA BIT/NO PARITY/ DENSITY LOW

If a user wants to modify the defaults with

RS-232C / 38400 BPS/7 DATA BIT/ EVEN PARITY / DENSITY HIGH

Press the Mode Button until the Error Lamp twinkles 5 times and release the button.

You will see the Power Lamp twinkles one time and

the Error Lamp twinkles 1 time.

This mode is RS-232C mode.

Press the Feed button one time, the Power Lamp twinkles twice and the Error Lamp

winkles 4 times.

Press the Mode Button one time, the Error Lamp twinkles 5 times and press

the Mode Button one more time, the Error Lamp twinkles 6 times.

(The baud rate has set to 38,400 bps)

Press the Feed Button one time, the Power Lamp twinkles 3 times and

the Error Lamp twinkles 2 times.

Press the Mode Button one time, the Error Lamp twinkles one time.

(The Data Bit has set to 7 data bit.)

Press the Feed Button one time, the Power Lamp twinkles 4 times and

the Error Lamp twinkles 1 time.