User's Manual

G aVVUUG

YWW^TWZTY]G

Press the Mode Button one time, the Error Lamp twinkles 2 times.

(The Parity bit has set to even parity bit.)

Press the Feed Button one time, the Power Lamp twinkles 5 times and

the Error Lamp twinkles 1 time.

Press the Mode Button one time, the Error Lamp twinkles 2 times after then press

the Mode Button again, the Error Lamp will twinkle 3 times

(The density has set to High)

If all mode have set, press the Mode Button and the Feed button at the same time after then release the

buttons at the same time.

The printer will print out the mode status which has modified.

(RS-232C/ 38,400 BPS/ 7 DATA BIT/ EVEN PARITY/ DENSITY HIGH)

If the status is not correct, please try it again according to the procedure.