User's Manual

http://www.woosim.com
14
2
2
.
.
5
5
.
.
S
S
e
e
t
t
o
o
p
p
e
e
r
r
a
a
t
t
i
i
o
o
n
n
m
m
o
o
d
d
e
e
.
.
1. Change the mode and option using the mode Code (Table1).
z POWER button : changing Printer MODE status.
z FEED button : changing OPTION status.
2. [Example] The defaults of the printer are :
UART/ 9600 BPS/8 DATA BIT/ NO Parity/1 STOP BIT/ Density LOW
If a user wants to modify the defaults with
Bluetooth/38400 BPS/7 DATA BIT/Even Parity/2 STOP BIT/Density HIGH
X
After pressing the POWER and the FEED button simultaneously,
if the ERROR lamp 5 turn signals POWER button is converted with
MODE functions
→ You will see present COMMUNICATION mode in the LCD.
→ Press the POWER Button two times.
(The interface mode has set to Bluetooth mode.)
X
Press FEED button one time.
→ You will see present BAUD RATE mode in the LCD.
→ Press POWER Button 2 times.
(The baud rate has set to 38,400 bps)
X Press FEED button one time.
→ You will see present DATA BIT mode in the LCD.
→ Press POWER Button one time.
(The data bit has set to 7 data bit.)
X Press FEED button one time.
→ You will see present PARITY BIT mode in the LCD.
→ Press POWER Button 2 times.
(The parity bit has set to even parity bit.)