User's Manual

http://www.woosim.com
15
X Press FEED button one time.
→ You will see present STOP BIT mode in the LCD.
→ Press POWER Button one time.
(The stop bit has set to 2 stop bit.)
X Press FEED button one time.
→ You will see present DENSITY mode in the LCD.
→ Press POWER Button two times.
(The density has set to high.)
If all the mode have set, press the FEED Button and the POWER Button at the
same time after then release the buttons at the same time.
The printer will print out the mode status which has modified.
(Bluetooth/38,400 BPS/ 7 DATA BIT/Even Parity/ 2 STOP BIT / Density HIGH)
If the status is not correct, please try it again according to the procedure.