User's Manual

WSP-i350 Rev. 4.1
http://www.woosim.com
20
 FEED button : changing Printer MODE status. (Power Lamp)
 POWER button : changing OPTION status. (Error Lamp)
[Example] The defaults of the printer are :
UART / 9600 bps / 8 data bit / No parity /1 stop bit / Density low /
Quality low / Mark use / Sensor High / 5 min Off
If a user wants to modify the defaults with
Bluetooth / 57,600 bps / 7 data bit / Odd parity /2 stop bit / Density high /
Quality high / Mark no use / Sensor Low / No use
 Press FEED & POWER Button during the Error Lamp flickers 5 times.
 You will see present COMMUNICATION mode in the LCD. (UART)
 Press the POWER Button twice. And then, interface mode has set to
Bluetooth mode.
 When you press FEED button once.
 You will see present BAUD RATE mode in the LCD. (9600 bps)
 Press POWER Button 3 times. And then, BAUD RATE has set to 57,600 bps.
 When you press FEED button once.
 You will see present DATA BIT mode in the LCD. (8 Data bit)
 Press POWER Button once. And then Data Bit has set to 7 DATA BIT.
 When you press FEED button once.
 You will see present PARITY mode in the LCD. (No parity)
 Press POWER Button once. And then the Parity bit has set to ODD Parity Bit..
 When you press FEED button once.
 You will see present STOP BIT mode in the LCD. (1 stop bit)
 Press POWER Button once. And then the density has set to 2 Stop bit.
 When you press FEED button once.
 You will see present DENSITY mode in the LCD. (Density low)
 Press POWER Button twice. And then the density has set to Density high.