User's Manual

WSP-i450 Rev. 1.0
http://www.woosim.com
16
2
2
.
.
5
5
.
.
S
S
e
e
t
t
o
o
p
p
e
e
r
r
a
a
t
t
i
i
o
o
n
n
m
m
o
o
d
d
e
e
.
.
Change the mode and option using the mode Code.
z MODE button : changing Printer MODE status. (Error Lamp)
z FEED button : changing OPTION status.
[Example] The defaults of the printer are :
UART / 9600 bps / 8 data bit / No parity /1 stop bit / Density low / Quality low
/ Mark use / Sensor low / Power down 5 minute
If a user wants to modify the defaults with
Bluetooth / 57,600 bps / 7 data bit / Odd parity /2 stop bit / Density high / Quality high
/ Mark no use / Sensor medium1 / Power down no use
X Press MODE Button and FEED button during the Error Lamp flickers 5 times.
→ You will see present COMMUNICATION mode in the LCD.
→ Press the MODE Button twice.
And then, interface mode has set to Bluetooth mode.
X When you press FEED button once.
→ You will see present BAUD RATE mode in the LCD.
→ Press MODE Button 3 times.
And then, baudrate has set to 57,600 bps.
X When you press FEED button once.
→ You will see present DATA BIT mode in the LCD.
→ Press MODE Button once.
And then Data Bit has set to 7 data bit.
X When you press FEED button once.
→ You will see present PARITY mode in the LCD.
→ Press MODE Button once.
And then the Parity bit has set to Odd parity bit.
X When you press FEED button once.
→ You will see present STOP BIT mode in the LCD.
→ Press MODE Button once.
And then the density has set to 2 stop bit.