User's Manual

WSP-R240 Rev. 2.0
http://www.woosim.com
16
2
2
.
.
5
5
.
.
S
S
e
e
t
t
o
o
p
p
e
e
r
r
a
a
t
t
i
i
o
o
n
n
m
m
o
o
d
d
e
e
In keeping on pressing the Feed and Power button simultaneously until after the
ERROR lamp blinks 5 times, the printer comes out at the circumstance to change
the printer mode. (refer Table 2)
 POWER button : use for changing OPTION status. (Error Lamp)
 FEED button : use for changing MODE status. (Power Lamp)
[Example] The defaults of the printer are :
RS-232C / 9600 bps / 8 data bit / No parity / 1 stop bit / Density low
/ Mark use / Sensor low / Power down 5 minute
If a user wants to modify the defaults with
Bluetooth / 57600 bps / 7 data bit / Odd parity / 2 stop bit / Density high
/ Mark no use / Sensor medium1 / Power down no use
 Press MODE & POWER Button during the Error Lamp flickers 5 times.
 You will see the Power Lamp and the Error Lamp flickers once.
 Press the POWER Button twice and the Error Lamp flickers 3 times.
And then, interface mode has set to Bluetooth mode.
 When you press POWER button once again, Power Lamp flickers twice and
the Error Lamp flickers once.
 Press POWER Button 3 times, Error Lamp flickers 4 times.
And then, baudrate has set to 57,600 bps.
 When you press POWER Button once again, Power Lamp flickers 3 times
and the Error Lamp flickers twice.
 Press POWER Button once, Error Lamp flickers once.
And then Data Bit has set to 7 data bit.
 When you press FEED Button once again, Power Lamp flickers 4 times
and the Error Lamp
flickers once.
 Press POWER Button once, Error Lamp flickers twice.
And then the Parity bit has set to Odd parity bit.