User's Manual

WSP-R242 Rev. 1.0
http://www.woosim.com
18
[Example] The defaults of the printer are :
USB / Density Low / Mark No Use / Sensor High / PWDN 5 min slp
If a user wants to modify the defaults with
Bluetooth / Density High / Mark Use / Sensor Low / PWDN No Use
 Press FEED & POWER Button during the LCD backlight flickers 5 times.
 You will see present COMMUNICATION mode in the LCD. (USB)
 Press the POWER Button twice. And then, interface mode has set to
Bluetooth mode.
 When you press FEED button once.
 You will see present DENSITY mode in the LCD. (Density low)
 Press POWER Button twice. And then the density has set to Density high.
 When you press FEED button once.
 You will see present MARK mode in the LCD. (No Use)
 Press POWER Button once. And then the mark has set to Mark Use.
 When you press FEED button once.
 You will see present SENSOR mode in the LCD. (High)
 Press POWER Button once. And then the sensor has set to Sensor Low.
 When you press FEED button once.
 You will see present PWDN mode in the LCD. (5 min slp)
 Press POWER Button six times. And then the Power down has set to
PWDN No Use.
If all the mode have set, press the POWER Button and the FEED Button
at the same time. After then release the buttons at the same time.
Bluetooth / Density High / Mark Use / Sensor Low / PWDN No Use