MODEL WSP-R350 (3inch Mobile Printer) Rev. 1.0 WOOSIM SYSTEMS Inc. #501, Daerung Technotown 3th, 448, Gasan-Dong, GeumChun-Ku, Seoul, Korea Tel : +82-2-2107-3700 Fax : +82-2-2107-3707 URL: http://www.woosim.com http://www.woosim.
WSP-R350 Rev. 1.0 Copyright WSP-R350 3inch mobile printer operator’s manual. Copyright ⓒ2014 by Woosim Systems Inc. All rights reserved. The information contained in this manual is the property of Woosim Systems Inc. And may not be reproduced in whole or in part without the prior written permission of Woosim Systems Inc. Trademark a registered trademark of Woosim Systems Inc. All other trademark are the properties of their respective companies.
WSP-R350 Rev. 1.0 Introduction The WSP-R350 is suitable designed for use with a growing variety of mobile devices. Bluetooth/Serial interfaces make the WSP-R350 the perfect comrade for applications such as point of transaction warehousing, distribution, point of sales, hospitality, gaming and healthcare. The general features of WSP-R350 printer are as follows: Pocket size (108.5 X 134.8 X 56.5mm) Light weight (399g) for true mobility. Very silent printing thru direct thermal printing method.
WSP-R350 Rev. 1.0 Operating Precautions Please follow the precautions below to enjoy and maintain the full performance of the printer. Using the Printer ● Be careful not to drop or bump the printer on a hard surface. ● Do not install the printer in direct sunlight or such areas.
WSP-R350 Rev. 1.0 Federal Communications Commission Radio Frequency Interference Statement FCC ID : QDDWSP-R350 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
WSP-R350 Rev. 1.0 CONTENTS 1. Specifications ..............................................................................................................................7 2. Setting up the printer ...............................................................................................................9 2.1. Printer & Accessories .................................................................................................. 9 2.2. Printer Features .................................................
WSP-R350 Rev. 1.0 1. Specifications Item Specification Printing method Direct thermal line printing Characters per line 64cpl (MAX) Character size Eng. : 9*24dots, 12*24dots Optional Characters Simplified/Traditional Chinese, Arabic, Cyrillic, Russian, Tukish, Greek, Japanese, Persian, Latin9 and Others upon request. Resolution 203dpi, 8dots/mm Print width 3-inch (72mm, 576dots) Printing speed 80mm / sec (MAX) Dimensions Weight (Including battery) Kor. : 16*24dots, [24*24dots] 108.
WSP-R350 Rev. 1.0 Item Battery Charger Environment Conditions MCBF (Mean Cycle Between failure) Specification Input (100~250V AC 50~60Hz) Output(8.4VDC/0.8A), 4hours full charge time Temperature Humidity Mechanical Head -10°C ~ 50°C (operating) -10°C ~ 70°C (storage) 30% - 80% (operating) 10% - 90% (storage) 37,000,000 lines Approximately 50 Km < Table 1 > http://www.woosim.
WSP-R350 Rev. 1.0 2. Setting up the printer 2.1. Printer & Accessories Your printer box should include these items. If any items are damaged or missing, please contact your dealer for assistance. Battery Pack Thermal roll paper WSP-R350 Belt Clip Battery charger adaptor Communication cable ▼ OPTIONAL MSR Car charger http://www.woosim.
WSP-R350 Rev. 1.0 2.2. Printer Features ▶ Part Name STANDARD Model MSR Model http://www.woosim.
WSP-R350 Rev. 1.0 http://www.woosim.
WSP-R350 Rev. 1.0 2.3. Dimensions ▶ Standard Model http://www.woosim.
WSP-R350 Rev. 1.0 ▶ MSR Model http://www.woosim.
WSP-R350 Rev. 1.0 2.4. Replacing the paper roll Note : Be sure to use paper rolls that meet the specifications. Do not use paper rolls that have the paper glued to the core because the printer can not detect the paper end correctly. 1. Make sure that the printer is not receiving data; otherwise, data may be lost. 2. Open the paper cover as the “One-Touch” way by pressing the button in the arrow direction like the picture. 3. Insert the paper roll as shown. 4.
WSP-R350 Rev. 1.0 5. To change paper width, move paper guide while pressing paper width change button as shown in the picture. http://www.woosim.
WSP-R350 Rev. 1.0 2.5. Power supply 2.5.1. Internal power supply The following specification is requested for Power supply. Battery Charger : DC 8.4V/0.8A Avoid using power supply which its power capacity of power current is extremely high. 2.5.2. Installing the Batter y NOTE : ● Before installing or removing the battery pack, ensure the printer is OFF. ● If the printer is not used for long period of time, remove the battery pack from the printer.
WSP-R350 Rev. 1.0 2.5.3. Recharging the batter y For recharging the battery pack, install the battery pack in the printer. NOTE : ● While charging the printer, turn off the printer power. ● Do not remove the battery during charging. ● The battery is consumable parts and when purchasing, compared to the use hour is gradually decreases. (Warranty 6 month) ● If the printer is not used for a long time, unplug the power cord from the printer and outlet.
WSP-R350 Rev. 1.0 2.6. Set operation mode In keeping on pressing the Feed and Power button simultaneously until after the ERROR lamp blinks 5 times, the printer comes out at the circumstance to change the printer mode. (refer to Table 2) ** Only the printer which support iOS Bluetooth interface comes out at the circumstance to change the printer mode. (Bluetooth Mode or Boluetooth(iAP) Mode). ** Manipulation methods : 1.
WSP-R350 Rev. 1.0 POWER button : use for changing OPTION status. (Error Lamp) FEED button : use for changing MODE status.
WSP-R350 Rev. 1.0 When you press FEED Button once again, Power Lamp flickers 5 times and Error Lamp flickers once. Press POWER Button once, Error Lamp flickers twice. And then the density has set to 2 stop bit. When you press FEED Button once again, Power Lamp flickers 6 times and Error Lamp flickers once. Press POWER Button twice, Error Lamp flickers 3 times. And then the density has set to Density high.
WSP-R350 Rev. 1.
WSP-R350 Rev. 1.0 MODE Power Down POWER Lamp ERROR Lamp (Green) (Red) 9 Option 1 No use 2 1 minute 3 2 minute 4 3 minute 5 4 minute 6 5 minute < Table 2 > Notice : Bluetooth(iAP) is the mode which is used in iPod, iPhone and iPad Whole aspect. http://www.woosim.
WSP-R350 Rev. 1.0 3. Interface 3.1. UART (Fig.3.1) The WSP-R350 printer has a UART(RS-232C or TTL) interface and is connected by means of a 5 pin mini USB socket. In the following table, the signals present on the Mini- USB socket are listed: ① UART(RS-232C) Pin no Signal Name Direction Function 1 TxD Output Transmit Data 2 RxD Input Receive Data 3 CD - Cable Detect 4 NC. - - 5 GND - Ground NOTE : ● When data receiving, when it removes the communication cable, it loses a data.
WSP-R350 Rev. 1.0 3.2. Bluetooth Category Specification Bluetooth Spec. Bluetooth Ver2.1 +EDR / Class2 (10m) Frequency Range 2.4GHz ISM BAND Data Transmission Rate 57600bps Fixed. Data bit 8 Data bit Fixed. Parity bit No parity Fixed. Stop bit 1 Stop bit Fixed. RF exposure warning This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum 20cm between the radiator and your body. 3.3.
WSP-R350 Rev. 1.0 4. Using the printer 4.1. Control panel (Fig.4.1) Button - FEED Button: When the printer is on, paper can be feed manually by pressing and holding the FEED button for more than one second. - POWER Button: ① When of 5 or more seconds presses and power comes to on or off. ② After pressing the POWER and the FEED button simultaneously, if the ERROR lamp 5 turn signals POWER button is converted with MODE functions.
WSP-R350 Rev. 1.0 Panel lamp - Power : Printer is ON and ready to receive data. (GREEN) - Error (RED) : Indicates a fault condition or a printer error. (i.e : no paper, paper cover opened. etc.) - Bluetooth : Indicates a Bluetooth connection status. (BLUE) - Battery Power : These lamps(Green) indicated the battery power remaining. (GREEN) The battery gain in quantity and these lamps are on the decrease. If so, you must recharge the battery by using the battery charger. 4.2.
WSP-R350 Rev. 1.0 4.3. Using the Belt clip Following the instruction of the arrow, please put the belt clip in the hole and turn and fix the screw to the right by using a thing like a coin. Afterward, you can use it like the picture below http://www.woosim.
WSP-R350 Rev. 1.0 5. Consumable Par ts 5.1. Recommended paper Type : Thermal Paper Paper width : 72mm Paper thickness : 60±5㎛ Outer diameter : Ø50mm or less Recording side : Outside of roll Cautions 1. Do not paste the paper to the core, and the roll paper which has near end mark printing on its near end is recommended. 2. Chemicals or oil may change the color of paper, or printed characters may fade. 3. Change of paper color starts from approx. 70 ℃.
WSP-R350 Rev. 1.0 6. Revision Histor y Date Version Aug. 13. 2014 1.0 Comments Initialize http://www.woosim.
