Information to the user This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Contents Before Setting up Brief Specification of LCD Monitor Precautions Setting up the LCD monitor Where is a good place to position the monitor? Please control Tilting Degree. Check before connecting the power cord and the signal cable !! How to connect the power cord and the signal cable to the LCD monitor. Connecting Your LCD Monitor Plug & Play Warm-up Time Adjusting The Monitor The Function Control Buttons How to use function control button How fo use the Hot Key.
BRIGHTNESS/CONTRAST USER COLOR OSD POSITION INFORMATION Appendix Appendix A. Specifications Appendix B. Display Modes Appendix C. 15-pin D-Sub Connector Appendix D.
1 Before Setting up This is 15.1 inch T FT-LCD monitor. Before Setting up the LCD Monitor, Please this manual read help your understanding ok. Brief Specification of LCD Monitor = Resolution : 15.1 inch XGA (1024 X 768 @60Hz) u Color display : 262,144 colors = DIMS (Display Power Management Signaling) u Viewing angle : LIR 76°75", UD 55/55" u Brightness : 200cd/ni = OSD (On Screen Display) u Auto Configuration : Hot key u DDC1/2B/2Bi : Plug & Play | zy According to PC system, DDC 1/2B may not be supported.
a == Precautions 230V Chock the voltage corresponds fo the local electrical supply before connecting the AC power cord, © Do not use Krone typo material (ex. Acetone, Ethyl ‘Alcohol, Toluene, Ethyl Acid or Methyl chloride, to clear the panel. It might permanently darn ago the panel. Never uss the damaged AC power cord. Don't put your LCD monitor in location with high tumidity and dust.
Don't touch the screen with a acute nail and pin "The LCD monitor consist of electrical devices. If the LCD monitor is damaged, contact immediately our service center. Don't use your LOD monitor in node direct sunlight.
2 Items User Manual LCD Monitor AC Power Cord 15-pin D-Sub Signal Cable If any items are missing, contact your dealer. Please make sure the following items are included with your monitor.
Where is a good place to position the monitor? Place the LCD monitor on a solid and flat surface. If dropped, the screen can be damaged easily. Please control Tilting Degree. You can ses a supporting prop on the backside of the LCD monitor. Tilt the screen until you feel comfortable for working Tilting Degree (Up/Down) : Degree J Check before connecting the power cord and the signal cable !! Turn off the PC power before connecting power cord and signal cable to the LCD monitor.
a == How to connect the power cord and the signal cable to the LCD monitor. AC Power Cord [] 15-pin D-Sub Signal Cable Connecting Your LCD Monitor 1. First, you can connect the power cord to the LCD monitor and AC outlet. 2. You can connect the signal cable to the LCD monitor and the PC system. Plug & Play The adoption of the new VASE( Plug and Play solution eliminates complicated and time consuming setup.
