4 Adjusting The Monitor The Function Control Buttons The function control buttons for monitor are located on the bottom side of the LCD monitor. MENU select POWER 3000 ¢ AUTO LED How to use the function control button.
a == How to use the Hot Key. Select @ aro : When you push Auto button, this will optimize image quality automatically. :Toucan adjust the contrast values that you want by this hot key. Br Bre fl : ‘While menu displays on the screen, don’t use hot key. ice If you want to use hot key, you must finish the menu status.
Main OSD Menu When you push the menu button, you can see below main OSD menu. AUTO CON FIG Lin = You can use this menu to optimize image quality.
m= POSITION Adjust Position un Changes the location of the image.
BRIGHTNESS/CONTRAST = Brightness : Change the overall light intensity of the images displayed. = Contrast : Change the ratio of light intensity between the brightest white and the darkest black. un Adjust contrast values that you want. m Default set : Discard current setting and replaces corresponding parameters with the factory default values about brightness/contrast. 4 Rightness (Pp Contrast Default Set EXIT CLOCK/PHASE Clock/Phase = When image is not clear, use clock/phase menu.
Phase (il Default Sst Exit If image is not clear (noise), you can adjust Clock/Phase. COLOR u The tone of color can ba changed from bluish white to reddish white. u Color Blue type u Color Red type = Ursa Color You can select the color.
USER COLOR = Red Galen / Green Galen / Blue Galen : You can adjust red, green and blue values that you want m Default set : Discards current setting and replaces corresponding parameters with the factory default values about user color Green Galen Blue Gain Default set Exit OSD POSITION [ssc u Sets the OSD menu display position. u H-Position : Moves the OSD menu to the horizontal direction. u V-Position : Moves the OSD menu to the vertical direction.
08D Function WH passion @§n V Position (3 Display Fun Default set Exit INFORMATION gel] m Shows the information of the current video signal. m 1024 X 768 : Current Resolution. m HS : Horizontal Sync by the graphic card. m VS : Vertical Sync by the graphic card.
Appendix A. Specifications Type Size Brightness Viewing Angle [LRU] Pixel Pitch Display Color Response Time Display Basic Resolution Maximum Horizontal Vertical Sync Signal Video signal Connector Sitting Degree (U/D) Plug & Play Input Consumption Standby mode Power Management Environmental Temperature Considerations Humidity Dimensions Outside Monitor Carton %The specification of this monitor is subject to be changed without notice to improve performance.
a == Appendix B. Display Modes Appendix C. 15-pin D-Sub Connector vv.
Appendix D. DIMS Power Saving Mode D-Sub This monitor has a built-in power management system called DIMS Power Saving Mode. This system saves energy by switching your monitor into a low-power mode when it has not been used for a certain period of ime. The available modes are “ON”, “Standby”, “Suspend”, and “OFF”. an wore and mpl Time pearling status Under ON Gi Active Active Active oat run Standby Alternating Inactive Active | Blanked Transgressor mode (0.
6 Troubleshooting hat you se gga Screen is blank and power indicator is off « Ensure that the power cord is firmly connected and the LCD ‘monitor is on. “out of range” message + Check the maximum resolution and the frequency of the video adapter. « Compare these values with the data in the Display Modes Timing Chart. “No signal input® message + Ensure that the signal cable is firmly connected to the PC or video sources. + Ensure that the PC or video sources are muted on.