Instruction manual

GREENSTAR CAMRAY EXTERNAL
flue
reset
boiler
reset
on
service
max
GREE
NSTAR CAMRAY EXTERNAL
flue
rese
t
boiler
rese
t
on
service
max
GREENSTAR CAMRAY EXTERNAL
flue
rese
t
b
oiler
rese
t
on
servi
ce
max
GREENSTAR CAMRAY EXTERNAL
flue
rese
t
b
oiler
rese
t
on
service
max
OPERATING THE APPLIANCE
FAULT CONDITIONS:
The ‘Boiler mode’ and ‘Lockout’ lights can
indicate some basic fault conditions.
1 Accessing Controls:
4 Unscrew the easy grip screws on the bottom
of the front panel. The panel will drop down
and can be removed.
2 Normal operation:
Boiler mode light ON
The appliance is in boiler mode, with a demand
for heat from the controls.
3 Both lights on:
Boiler not firing
4 Check the level in the oil tank.
4 Press the Reset button (A). The boiler
should fire.
4 If there is no response, wait 2 minutes and
press the Reset Button (A) again.
4 If Lockout light stays on, do not attempt
further resets. Contact your Service
Engineer for advice.
4 Boiler mode light on, lockout light off:
Boiler not on -
No heating/hot water
4 Press Reset Button (B), press Reset Button
(C) both are below the fascia.
4 If the boiler remains off, contact your Service
Engineer for advice.
4 If this fault re-occurs contact your Installer or
Service Engineer.
5 Both lights off:
Boiler not on -
No heating/hot water
4 Ensure there is power supply to the boiler.
4 Check the programmer is set to ON and
thermostat is calling for heat.
4 Ensure that the Service switch is in Boiler
mode.
4 If there is power supply to the boiler contact
your service engineer for advice.
2 NORMAL OPERATION:
3 BOTH LIGHTS ON:
4 BOILER MODE LIGHT ON LOCKOUT LIGHT OFF:
5 BOTH LIGHTS OFF
1 ACCESSING CONTROLS:
OPERATING THE APPLIANCE
G
R
E
E
N
S
T
AR C
AMRAY EXTERNAL 12/18 - 18/25 - 25/32
8 716 112 711a (02.07)
9
USING YOUR
APPLIANCE
A
B
C