Instruction manual

ELECTRICS
•
= EARTH
•
= PERMANENT LIVE
•
= NEUTRAL
•
= SWITCHED LIVE
O
OUTSIDE BOILER
INSIDE BOILER
1 2 3
1 2 3 4 5 6
3
2
E
N
L
REMOTE 2 OR 3 PORT VALVE CONTROL SET
USING REMOTE PROGRAMMER:
Key to components:
O - REMOTE JUNCTION BOX (10-way) to
connect the following (refer to manufacturers
instructions):
Mains wiring 230V 50Hz, fed via a circuit
breaker incorporating earth leakage protection.
Hot water tank thermostat.
Room thermostat.
System water valves.
Circulating pump.
External programmer.
E - TERMINAL CONNECTOR BLOCK.
Remote (10 way) junction box (O)
requirements:
The junction box (O) must be a terminal block
type, current rated to at least 5 amps.
A 5 amp fuse must be fitted to the mains
supply.
The junction box (O) must be fitted externally
to the boiler.
If an additional frost thermostat is required, it
should be connected to the remote junction bo.
ELECTRICS
INSTALLATION & SERVICING INSTRUCTIONS FOR WORCESTER GREENSTAR CAMRAY EXTERNAL &
EXTERNAL SYSTEM 12/18-18/25-25/32
8 716 115 667a (05.2009)
32
INSTALLATION
CAMRAY EXTERNAL REGULAR