Operating instructions

3
GENERAL
INFORMATION
GAS SAFETY (INSTALLATION AND USE) REGULATIONS 1998
It is the law that all gas appliances must be installed by a competent person in accordance
with the above regulations. Failure to correctly install appliances correctly could lead to
prosecution. It is in your interest and that of safety to ensure compliance with the law. The
manufacturers notes must not be taken, in any way, as over-riding statutory obligations.
IMPORTANT: To get the best from your Worcester W125 please read these instructions
carefully.
NOTE: In the event of a fault the appliance should not be used until the fault has been
corrected by a competent person.
GENERAL DESCRIPTION
The W125 is a flueless gas fired singlepoint water heater.
The appliance does not require a flue. It is essential that the correct installation
requirements are satisfied. This appliance is intended for intermittent use only and should
not be in use for more than 5 minutes in any one draw-off, must not be positioned in or
adjacent to a bedroom or any room containing a bath or shower.
It is the law that all gas appliances are installed by a Corgi registered installer.
Failure to correctly install appliances can lead to prosecution.
Technical Data
Nat. gas L.P.G.
Rated Input (Qn) 10.4 kW 10.4 kW
Maximum Rated Output (Pn) 8.7 kW 8.7 kW
Minimum Rated Output (Pmin) 4.4 kW 4.4 kW
Gas Rate (maximum)
1
.1 m
3
/h
0.8 kg/h
W125
Appliance Type