User manual

Connecting the speakers to 70V output
0 70V 0 70V 0 70V
100V70V25V
4 8 16
COM
Connecting the speakers to 100V output
0 100V 0 100V 0 100V
100V70V25V
4 8 16
COM
20. "INPUT 1","INPUT 2", "INPUT 3" and "INPUT 4" Inputs sensitivity and XLR
Phantom 24V switch
21. "INPUT 1", "INPUT 2", "INPUT 3"and "INPUT 4" Inputs
"Input 1"
By turning these switch onto the "LINE" position the"IN1", "IN2", "IN3", "IN4" input can be
connected to an audio source with high level signal output. By turning these switches onto
the "MIC" position the "IN1","IN2","IN3", "IN4" input can be connected to a dynamic
microphone with low impedance. By turning these switch onto the "24V" opsition connects
the "24V" phantom supply on XLR of pin2 and pin3 of inputs "IN1","IN2","IN3","IN4",
necessary to operate condenser type microphone which require this type of external supply.
It is recommended to use this switch with the general volume set on minimum.
These three balanced/unbalanced combination type jack (XLR and 6.3mm) inputs, meant for
the connection of condenser type microphone that accepts 24V phantom power, dynamic
microphone (30- 600 ohms) or a high level sound source (e.g. AM/FM tuner, cassette desk,
CD player, etc.). In case you are using, it is necessary to use the switch (20). has a
"Voice Priority" function that excludes all the other inputs as soon as a message is transmitted
with a microphone; it is possible to exclude this function by calling a SHOW SERVICE
CENTER.
Balanced microphone
3-pin XLR plug
(seen from welded side)
Unbalanced microphone
3-pin XLR plug
(seen from welded side)
Unbalanced microphone
Mono jack
Conectando altavoces a la salida de 100V
0 100V 0 100V 0 100V 0 100V
Z4
Z3
Z2
Z1
COM
18. Terminal de Salida de Zona
El terminal de salida conecta a los cables del altavoz. La cantidad total de W de un
altavoz depende de la potencia nominal para zona 1_4. Cuando se usa un selector de
zona, no se pueden usar los altavoces de baja impedancia. La preconfiguracion es de
salida de voltaje constante de 100 V.
19. Terminales de Salida
Estos 5 terminales permiten conectar a los altavoces.
Conectando altavoces a la salida de 4 ohm
+
4 ohm
100V70V25V
4 8 16
COM
Impedancia total 4 ohm
8 ohm 8 ohm
-
+
-
+
100V70V25V
4 8 16
COM
Conectando altavoces a la salida de 25V
0 25V 0 25V 0 25V
100V70V25V
4 8 16
COM
PA 190 USB/R - PA 240 USB/R User Manual/Manual de uso Pag 8
PA 190 USB/R - PA 240 USB/R User Manual/Manual de uso Pag 21