Instruction Manual

Pinnacle 2
™
!
Must install 4 screws within
6" of front of track.
!
Be careful not to
drill through worksurface.
Installation Instructions
3⅝"
3⅜"
¼"
ø⅛" x ¾" deep Pilot Hole
9½"
Front edge of worksurface
(dashed line)
C
L
Workrite Ergonomics | 800.959.9675 www.workriteergo.com
ø⅛" x ¾" deep
Pilot Hole
!
Front edge of track may be
recessed up to 2" from front
edge of worksurface for
increased stowability.
Drill ⅛" diameter x ¾"
deep pilot holes at
marked locations.
Remove template.
Tape template to
underside of
worksurface.
Position template so
dashed line runs along
front edge of
worksurface.
Install two #12 x ¾"
wood screws into
keyhole pilot holes.
Leave a gap of
approximately ⅛"
between head of screw
and worksurface.
⅛"
gap
Keyhole
Drill ⅛" diameter x ¾"
deep pilot hole
s and
install remaining
#12 x ¾" screws.
Tools Required::
⅛" bit
+
Phillips head
driver
Slide track keyholes onto
screws.
Tighten keyhole screws.
!
Do not remove arm from track.
Do not remove front end trim from track.
1500144 Rev A