Workrite Sierra HX™ Pin Assembly Instructions for 3-Leg Pin models #1500168 - Rev a
Workrite Sierra HX™ 2-Leg Front-Crank Workcenters - Assembly Instructions Parts grouped by carton A Tabletop (size and shape differ for each model) Qty: 1 B C Long Brace Qty: 1 Short Brace Qty: 2 For assembly of two-piece tops, please refer to separate instructions.
Workrite Sierra HX™ 2-Leg Front-Crank Workcenters - Assembly Instructions 2 Assemble Legs a Attach one Leg Cap (F) to the top of Center Leg (J) and each Side Leg (D) using Machine Screws (G). Do not tighten screws completely. Be sure Leg Caps face each other. b With legs on their sides, pin side down, attach a Long Brace (B) to top of each Side Leg (D) using Machine Screws (G). The Braces should have the lips on top, facing away from the legs. Do not tighten screws completely.
Workrite Sierra HX™ 2-Leg Front-Crank Workcenters - Assembly Instructions 3 Attach the leg assembly to the worksurface a Lay out the leg assembly in the proper location. Attach assembly to Top (A) using 20 Sheetmetal Screws (H). b Tighten all screws completely. a H b A 4 a Adjust Workcenter Height For safety and ease of adjustment, set workcenter height while table is upside down. Pull Ring Pins from each leg and raise or lower legs to desired height, then re-insert pins.
