Assembly Instructions for 3-leg Workcenters Owner's manual

Workrite Ergonomics | 800.959.9675 www.workriteergo.com 5
Sierra Series Workcenters - Assembly Instructions for 2 and 3-leg Tables
6
AttachControlBoxtoTabletop
If you do not have a Workrite tabletop:
PlaceControlBoxinpositionanduseapenciltomarkpilotholeplacement.Controlboxshould
beplacedtowardsrearcenteroftabletop.BesuretoplaceamarkinthesmallpartofMounting
Flange’skeyholeopening.RemoveControlBoxanddrillpilotholeswheremarked.
WithControlBoxpositionedoverpilotholes,attachone#8x⅝"MountingScrewthroughthe
MountingFlange’sopening.
Attachanother#8x⅝"MountingScrewthroughMountingHoleatbackrightofControlBox.
5
a
M1
M2
M3
MountingFlange
G
H
a
b
b
H
AttachCableSpoolsandVelcroTabs
AttachcablespoolsandVelcro
®
tabs to underside of tabletop as indicated in instructions contained
withinCableManagementKit.IfyoudoNOThaveaWorkritetabletop,mountcablespoolsina
convenient location between legs and control box.
RefertoinstructionsinCableManagementKit.
K
If you have a 3-leg table,
mount Control Box on
same side of tabletop as
switch to allow switch
cord to reach Control Box.
MountingHole