Assembly Instructions for 3-leg Workcenters Owner's manual

8 Workrite Ergonomics | 800.959.9675 www.workriteergo.com
Sierra Series Workcenters - Assembly Instructions for 2 and 3-leg Tables
Verify successful assembly
Three-legtables:
Afterinitialization,three-legtableswillshowcurrentheight,ininches,inswitchdisplaywindow.
Two-leg tables:
Afterinitialization,two-legtableswillshowcodeE31,indicatingthatathirdlegisnotpluggedin.
Thisisnormal.Presstheupbuttonmomentarilytoclearcodeanddisplaylegheight.
Whattodoifyougetanerrorcode:
Anyothercodeappearingintheswitchdisplaywindowimmediatelyafterinitializationindicates
anerrorhasoccurred.
First,tryraisingthetableslightlybypressingtheuparrowbriey-thismaybeallittakesto
cleartheerror.
Ifthatdoesnotcleartheerror,usethefollowingprocedure:
1. Unplugthepowerfromthecontrolbox.
2. Reseateachofthelegcablesandtheswitchcableintocontrolbox,makingsuretheyare
rmlyconnectedandcompletelyengaged.
3. Fortwo-legtables,besureyouarenotusingterminalM3(seeStep10).
4. Pluginpowercableagain,andre-initializebyholdingthedownarrowuntiltablemoves
slightlyupwards.
5. Raisetablelegsslightlybybrieypressingtheuparrow.
Ifyoustillencounteranerror,pleasenoteerrorcode(ifshown)andcallWorkriteCustomer
Service.
12
10
Initialize Legs
Afteralllegsandtheswitchareconnected,andthepowercordhasbeenpluggedin,holdthe
downarrowontheswitchuntilthelegswillmakeashortmotiondownandthenbackup.This
initializesandsynchronizesthetablelegs.
or
+
2
3
1
5
10
15
20
25
3035
40
45
50
55
60
You must complete
this initialization
step or your table
will NOT function
properly.
Hold down until
table moves
slightly upwards.
Adjust Leveling Guides
Ifnecessary,adjustlevelingguidesontablefeettoleveltheworksurface.
11