Sonoma Series™ — Pin Height Adjustable Workcenters Sonoma Series BASIC ™ Assembly Instructions 1450 Technology Lane • Petaluma, CA 94954 • 800-959-9675 • www.workriteergo.
Sonoma Series™ BASIC Workcenters PARTS LISTING Quantities indicated vary for two leg and three leg workcenters. Feet (2 or 3) Top (size and shape differ for each model) If Workrite is not supplying the top, it is installer’s responsibility to position the base under the worksurface to provide maximum stability. For assembly of two-piece tops, please refer to separate instructions.
Sonoma Series™ BASIC Workcenters ASSEMBLY INSTRUCTIONS OPEN ALL PACKAGES AND VERIFY THAT YOU HAVE ALL THE HARDWARE AS INDICATED IN THE PARTS LISTING. To assemble you will need a #3 tip Philips screwdriver and 7/16" wrench or socket. STEP 1 STEP 2 Fro Attach Top Bracket to smallest end of each leg assembly using 3/4” button head machine screws. This end is up and attaches to the underside of the worksurface. nt Fr on t Insert Foot Caps into ends of foot. Screw in Leveling Glides.
Sonoma Series™ BASIC Workcenters ASSEMBLY INSTRUCTIONS STEP 5 Slide Crossbar onto Crossbar Brackets and attach with two machine screws to each bracket. If you are assembling a three leg table, note that the middle leg is oriented at a 45° angle. The side with the double flange Crossbar Bracket faces the front edge of the table. STEP 7 It is easiest to adjust the height while the table is upside down. Pull the Ring Pins from each leg and raise or lower legs to their desired height and re-insert pins.
