Assembly Instructions User Manual

1450 Technology Lane • Petaluma, CA 94954 • 800-959-9675 • www.workriteergo.com Page 5
1500068 • Rev. C
Sonoma Series
™
PREMIUM Workcenters
1450 Technology Lane • Petaluma, CA 94954 • 800-959-9675 • www.wrea.com Page 5
ASSEMBLY INSTRUCTIONS
Flip table over and adjust leveling glides so that the
table does not wobble. Run table up and down one
time and then tighten all top bracket screws.
STEP 8 STEP 9
It may be necessary to adjust the display height
readout. The low height will vary depending on the
ooring surface and adjusted height of the leveling
glides. To obtain an accurate readout, lower the table to
its lowest position and measure from the oor to the top
of the worksurface.
Change the display by pressing and holding the
“S” button, hit the UP or DOWN button until the
display shows the correct height.