Sonoma Series PREMIUM ™ Electric Height Adjustable Tables USER GUIDE 1450 Technology Lane • Petaluma, CA 94954 • www.wrea.
We are delighted that you have chosen this quality height adjustable workcenter from WorkRite Ergonomics. This user manual will tell you how to use and maintain your Sonoma Series™ Premium workcenter. Before our products leave the factory they undergo full function and quality testing. However, should you experience problems with your system, please contact our customer service department at 800 959-9675. WorkRite provides a warranty on all of its table products.
Warranty: WorkRite warrants to the original purchaser that the products it manufactures are free from defects in design, material and workmanship. With prompt written notice, WorkRite will repair or replace, free of charge, any product, part or component which fails under normal use as a result of such defect.
Description of Sonoma Series™ Premium System: Each Premium leg assembly is equipped with a motor. Parallel memory drive is ensured by means of software in the control box that also takes account of offset loads on the worksurface. Soft start and stop are also part of this software. Duty Cycle: Irrespective of load, the duty cycle of this system is 10%. This equates to 6 min. per hour or a maximum of 2 minutes of continuous use.
Drive to a stored position: Press memory button 1, 2 or 3. The display will flash “GO1”, “GO2” or “GO3” for 3 seconds. Within the 3 seconds press UP or DOWN button and keep it pressed until the table stops in the stored memory position. While running to a stored position, the display will read GO1, GO2 or GO3 until it reaches the position. The height will then be shown. Releasing the UP or DOWN button will abort the memory drive.
OTHER HEIGHT ADJUSTABLE WORKCENTERS FROM WORKRITE ERGONOMICS SELECT: Single Column electric height adjustable VALUE: Crank height adjustable BASIC: Pin height adjustable 1450 Technology Lane • Petaluma, CA 94954 Phone: 1 (800) 959-9675 Fax: 1 (800) 930-8989 www.wrea.