Operation Manual

AFTER SALES SUPPORT:
Telephone: [phone]
E-mail: [e-mail]
AFTER SALES SUPPORT:
Telephone: [phone]
E-mail: [e-mail]
20 21
• The width symbol “W“ in the display flashes and shows the next
measurement to be carried out. Press the READ button in order to
obtain the width measurement, which is shown in the upper section
of the display (Step 2);
The area is automatically shown in the lower section of the display;
• Pressing the READ button again switches back and forth between
length and width in the upper section of the display;
− Press the MODE button in order to delete the data from the
display – now a new area calculation can be carried out.
− In order to switch the measurement mode, press the MODE button
again;
Tips:
With single pressing of the MODE button, you can switch back and
forth between the length, area and volume. If there is data available
in the display, pressing the MODE button will delete the current
data – the mode remains unchanged.
• Adding memory to last measurement result: Press +/= for at least
2 sec. until a double beeping tone sounds. “M” will disappear from the
display. Only the saved value will be shown in the bottom of the display.
• Press the +/= button briefly – the result of the last measurement +
saved measurement will appear in the display.
Area
• Press the MODE button in order to switch into the area mode and
appears to calculate the area of a space;
• The length symbol “L“ in the display flashes and show the first mea-
surement that you have carried out. Press the READ button in order
to obtain the length measurement, which is shown in the upper section
of the display (Step 1);
OperationOperation